...open the tray 1 door and pull out tray 2. 3. Push down on two tabs to release the tray 1 panel. 4. Remove the jammed sheet by pulling it straight out. 5. Push up on two tabs to replace the tray 1 ...
...Open read door and pinch blue latches on fuser and pull it out. Inspect the sensor flag for correct movement and any paper obstructions in the fuser rollers. Re-install fuser and Confirm rear door ...
Question about HP LaserJet Office Equipment & Supplies
...tray by 180 and/or turn it over. 13.2 Paper Jam Open Input Trays Paper-stopped jam at paper-feed area. 1. Check the input area for obstructions such as paper in the path. Also check to see if the ...
...Tray 2 from the product. b) Open the front door. c) Remove three screws (callout 1). Starting from the left side tabs (callout 2),and then remove the cover from the product. TIP: Opening the ...
...open the rear door and lift the green lever on the side and release the paper. make sure the setting in the toolbox is set to Tray 1: Any size / Any Type tray 2: A4 size / Plain Type Rgds, ...
...tray 2 is correctly set to bond or (8 1/2 x 11").Open the rear door while printing and inspect pickup roller while viewing with flashlight. If the rear paper adjustment is not correctly set it will ...
...OPEN INPUT TRAYS Paper-delay jam at paperfeed area. 1. Ensure that paper trays are loaded and adjusted properly so media can feed from the tray. It might be necessary to reduce the stack height of ...
tray 1 bypass path. Look back in there for the tiniest scrap of paper left behind. Next, if nothing is found, open the rear door, and again with a flashlight, look down in the bottom of the paper path
Question about HP LaserJet Office Equipment & Supplies
...tray and replace any damaged paper. Replace the paper and try to use the ADF once more. 2 Turn off the printer and open the ADF cover. Clean the paper roller and separator pad with a damp microfiber ...
Question about HP LaserJet Office Equipment & Supplies
...1. Trays are loaded improperly or overfilled. 2. Tray 2 or tray 3 is removed during print job. 3. The top cover is opened during print job. 4. The media that is being used does not meet HP ...
146 questions posted
Usually answered in minutes!
1,429 Questions
1,001 Questions
724 Questions
663 Questions
593 Questions