Haier 20.5 cu. ft. / 580 liter Upright Freezer HUF138PA "fridge door" Questions

...is there only when the door is closed. it stops no sooner the fridge door is opened. thats typically an air circulating fan thats either faulty or something is touthing the blade. open up and

closes letting the cold air go into the fridge and when the fridge is cold enough the door will close agin. This is not something that you will see happening it is normally concealed behing a diffuser

...fridge.Any ideas? check that the correct thermostat is installed and that the element wire is connected.check door rubber and door hinges.check if it has independant defrost timmers and if it is ...

...fridge door seals are attached to the door by screws. If you flap the seal up from the bottom you should see some screws. if you go to the site below it gives your guidance on replacing the seals on ...

fridge freezer, the freezer door is not closing -please help check if noting broke in the door locking mechanic. Or check if not too much ice is pressing the door open. But if you don't hear the click

...door , the cold air through to fridge air outlet ok but when the freezer door shut and than no air to the fridge the fan is working. first look for an air vent in the bottom of the fridge(a small ...

...door. The fridge temp control works fine. What might be the problem here? Hi, You are probably right that it is always running. This is because the thermostat/sensor has gone bad. The fridge adjusts ...

...fridge door is open The fridge is 13 years old. I have thoroughly checked and cleaned the fridge and there is definately no mouldly or sour food in fridge. Could there be a leak somewhere and is it ...

door on Electrolux fridge freezer want to change door from right hand to left hand opening on Electrolux ENB 39405 fridge freezer. But top door mount doesn't appear to be reversible. Any ideas? Thanks

Fridge door sagged and needs adjusting. The Fridge door is sagging and catching on bottom frame. It needs adjusting but I can't see how to do this or a solution in the manual. the screw holding the ...