Haier HBF05EBSS Commercial Beverage Dispenser "wire protector relay" Questions

protector with a 3 n 1 hard start hardstart came with 5 wires I know the placement of the 3 on the compressor but not sure on the 2 black power wires my relay had a pink and blue wire hooked to it and

wire connects to the protector and what other wire connects to the compressor. The wire that needed connected are Red that comes from the freezer and white and black. can you help me with this problem

...protector (labeled "B") and the electrical terminals of the compressor motor. Remove the compressor relay by pulling it straight off from the compressor.Pull the wire off of the side terminal of the ...

...protector and the electrical terminals of the compressor motor. Remove the compressor relay by pulling it straight off from the compressor. Pull the wire off of the side terminal of the relay. It is ...

...protector and the electrical terminals of the compressor motor. Remove the compressor relay by pulling it straight off from the compressor. Pull the wire off of the side terminal of the relay. It is ...

...protector on mine is a P6R8MD and the Compressor is a LG MA53LBCM. Now for the question, What do I do, How do I fix it ? any suggestions ? Do you have any technical background? There is a simple and ...

...wire connects to the bi-metal overload protector built into the relay. That is the bottom center connection terminal on the compressor. The other A/C line in wire is the hot wire and it connects to ...

wire plug in like plastic switches. The one on top I shook it ,sounded like dust inside, so I made me a couple jumpers and compressor started, but only ran for about few minutes, then got real hot and

...PROTECTOR ON THE SIDE OF THE COMPRESSOR. UNPLUG UNIT AND PULL START RELAY OFF AND SHAKE. IF SOUNDS LIKE IT'S FULL OF GRAVEL IT'S BAD, OR GET VOLT /OHM METER AND CHECK CONTINUITY BETWEEN THE START AND ...

...protector/start relay. Disconnected the power again, and pulled the overload protector. My question being, is it safe to simply replace the protector and switch, or is there something deeper going on ...