Question about Jura Capresso Impressa Coffee Makers & Espresso Machines
...in the left panel (seen from behind) and pull back. The other panel you use your fist and hit lightly backwards, it is ligthly snapped in the front panel. Then you will have free axcess for
...front. It makes removing the sides a little easier. Next, open the top lids, beans and water, and find the black pan screws in the top front and remove. Now, facing the rear of the maker, there are ...
Question about Jura Capresso Impressa Coffee Makers & Espresso Machines
...front panel is free to swing open except for the pipes connecting the front 4) unclip the steam assembly - there are a couple of plastic catches on the top. this will free the steam assembly from the ...
Question about Jura Capresso Impressa Coffee Makers & Espresso Machines
...front panel becomes the challenge as there are loads of tiny pipes connected to it. If you gently ease the accessible ones off and take care as some are held in place with a small spring clip you ...
Question about Jura Capresso Impressa Coffee Makers & Espresso Machines
front panel. It's a major operation involving opening the machine. Disconnct completely from mains power. On the rear there are 2 screws middle top and middle bottom When they are removed the back can
Question about Coffee Makers & Espresso Machines
panel, there might be 8 screws holding it on to the machine, then loosen the screws holding the plastic front panels from bottom and remove the clip in the back, you might have to bend the side panels
...removing the only screw (don't drop it in the grinder). Then remove the scute for the cleaning tablets. Then remove the two screws that were next in front of the scute. Remove the water tank. Under ...
...front panel to reveal the display board, remove and replace it along with the water tight seal. Plug the new display into the control board, reattach the top front panel to the body of the machine, ...
Question about Jura Capresso Impressa Coffee Makers & Espresso Machines
...front panel to reveal the display board, remove and replace it along with the water tight seal. Plug the new display into the control board, reattach the top front panel to the body of the machine, ...
...front top panel Undo I think 3 screws holding top cover, 2 out wide on the top front and one down a tube in middle back. Lift front edge of top cover up and wrack it about a but to release the ...
190 questions posted
Usually answered in minutes!
151 Questions
110 Questions
108 Questions
37 Questions