Kenmore 55612 / 55614 / 5561 / 655619 Side by Side Refrigerator "set temp" Questions

...quick freeze, set temps by up and down temp buttons, once done, push vacation button. your temps are now set, turn the unit off for 2 mins the turn on. reaction is now set and normal. regards ...

set my freezer temp at? i have a side by side hot point Hello I can help with this problem , You can set it to the factory setting thats normaly in the middle , wait 24 hours for temps to equalize and

...you set the temp (at 34) the refrigerator display changes to show the current temp inside your refrig. (apparently it was 65) As the unit runs, this display will lower until arriving at the set

...set the temp control to the warmest setting and the cooler is still freezing product, you will need to have the cooler serviced be a refrigeration tech. It will most likely be a bad control but there ...

...temp will go to new setting but when set light goes off it reverts back to 14 and 74. note: 74 is above the max setting of 47. please help. Unplug it for 2 minutes to do a hard reset. If it does not ...

...set temp is only displayed while you are setting it. It maybe in defrost and you would see higher that set temp valves, if after an hour you do not see the temp come back down to normal operating ...

...temp it beeps to tell you the temp is set and then the display returns to what the temp is actually inside the refrigerator you will have to allow 24HRS of operation to achieve the new temp you

Set temp to 46 deg(highest for fridge), temp ranges from 30 to 46 deg inside model gi5fsaxvy02, french double door with temp set at 46 deg, i used the thermometer to measure temp on the bottom ...

set the temp controls to warm up the temp? Is the lower setting warm or cold? Good day, The higher the number the colder the temp. 1 being the warmest. It takes 12 to 24 hours to realize a new setting

...set temp but doesn't maintain temp after it falls. Temp reading on display stays at set temp even when temp falls. Have to turn power off and back on for it to read actual temp and then it starts ...