KitchenAid KSM150PS Artisan Series Stand Mixer "lift loose" Questions

...lift works fine, doesn't slip or anything. You may be correct about a loose spring. Check this: Carefully lay the mixer on its back side to access the bottom of the mixer. Remove the cover screen ...

loose. The bowl lift will hand down. This is ok and will not hurt the interior linkage. Using oven cleaner spray all sides of the columns where the lift slides. The inside back of the lift that slides

Lift head. In the lifted position you will see the head of an adjusting screw. Turn it to the left say a half turn. 2- Lower head and see if it is still too low. If so, do it again. I had to turn mine

...lift does not work. Evidently a screw came loose and parts came off. How do I fix it? Yikes!!! How old is your mixer? In most cases in a bowl lift model, the plastic lift mechanism breaks. It is not ...

...lift lever on hobart HL200 loose, i can actually pull it out. There is a hole in the lever where it looks like a pin should be there to secure it. What can i do? ...

...lift-top and the top seems to be loose and wobbles as it mixes. help? Hi, W/D here. If you raise the head of your mixer, and look under the raised part, you'll see a silver screw head with a slot for ...

...loose its finish at the point. I cleaned and reseated the piece to hold the bowl in place and purchsed a new flat beater - 11 months later the fnish is off again. Is ther an adjustment? Usually there ...

...loose. Is there a way to tighten it up -- would like to know how to get to the screws holding the head to the base. Thanks! Referring to the diagram on: ...

...t want to break something trying to pull the blade out. Have tried spraying a cleanser to soak it loose. you need to lift the beater then twist it will come off i have the same mixer thanks from ...

lift up firmly and rotate the attachment counter clockwise as it is lifted off the planetary mounting pin, then the attachment should just fall off unless you are full of dried "Gunk" then you have to