...From it you can see how to remove the case cover and access the gear train. You may have to replace the shaft if its groove is worn allowing the retaining ring to slip
cover to check the belt. If belt is good and not slipping, is the operator handle working on /in the bowl lift gear box? If not, could be broken shear pin on handle or worn out parts in gear box. Next
...to insert into the threaded hole so that it would jam as I tightened it. I then greased all the gears with a white machine grease and pressed the roary cover plate back onto the shaft. I then put ...
...head shaft. Remove the mixing head housing. Lift up on the motor housing to remove it. The motor/gear housing is the top protion of the mixer. Its loaded with grease so do this over a covered ...
...cover). I suspect that one or both of the brushes is (are) not seated properly. Did you remove the brushes to replace them or were you just inspecting them, when you replaced your plastic worm gear? ...
...Gear. You?ll need a regular or Phillips screw driver, retaining clip pliers, and punch driver. When you remove the grease form the transmission cover and gears, be on the lookout for pieces of the ...
...falls within this manual), and select the first file KSM50P.pdf (438.31 KB) listed under Parts List (4) and then check to verify this matches your mixer model. Turn to pages 4 & 5, titled ?Case, ...
457 questions posted
Usually answered in minutes!
493 Questions
285 Questions
205 Questions
183 Questions
89 Questions