...water heater model # 42vp50fw. It suddenly stopped working. It will try to ignite. The igniter will glow and the call for gas will ignite the burner. After a few seconds, it will cut off. Is that a ...
Question about Water Heaters
...lights and my water heater is working. Make sure the electricity is turned on, most new units have an electrical ignitor which must be turned on and heat up before it will allow the gas to come
Question about Vanguard International Water Heaters
...as most use 208-220 volts! If it is a gas water heater, it could be a bad thermocouple, ignitor, gas valve. My advice to you is to call a qualified service company to come repair your water
Question about Water Water Heaters
...For a gas water heater it would be a plumber who is gas certified. see if unit has a pilot light look on gas valve if it says pilot try relighting if no pilot see if ignitor glows when calls for ...
...You may have instant hots for the sinks, a small heater for each location which won't be on the tub. If there is a flame fail the hot water heater is not working. Check the flame sensor and
...water heater for my camper is not working properly. It will not spark on its own but even when i use a bbq lighter it will turn the flame on for about 5 seconds then it will turn off and shut down ...
...water heater model #PVP50-1 (50gal) powerglow ignitor will not relight, we have tried to reset, but wil not relight, what do we do now? Hi, The ignitor has gone bad... you will need to find a ...
Question about Water Water Heaters
...water. The power vent is running but neither the ignitor or the burner is. If I turn off the power switch and gas switch then turn them back on, it will always start the ignitor and burner. Do you ...
...is not working 1) Copy following link for igniter troubleshoot resources: http://waterheatertimer.org/How-to-troubleshoot-gas-water-heater.html#igniter Faulty wires bad ignitor or bad ground ...
how to test a norton ignitor if it is good /271y ignitor does not work The HSI resistance should be below 200 ohms when ignitor is at room temp (68-70°). Don't test the HSI if the unit has been ...
18 questions posted
Usually answered in minutes!