SOURCE: wishbone front offside bmw mini one
you have to put the wishbone on 1st, the ball joint nut on and the front one den guide it in the hole and use a big lever with plenty of wd 40 and it will go in, i jus did one the other day, i had to change dat rear wishbone bush which was a nightmare to do
SOURCE: Can not remove rear tires after removing lug nuts, wheels are jamed onto hub.
spray pentrating oil around where wheel meets hub and also around lug bolts let set for about 15 min then take a sledge hammer and hit from underneath make sure the truck is blocked up good for safty
if that doesnt work take a small sissor jack between the rim and the fram and put a lot of pressure on it then hit it with the sledge from underneath
SOURCE: 1993 F150 4x4 w/ auto locking hubs - rotor removal
There are some special 4 tooth and hex sockets for removing the nuts inside the hubs of the truck.
YOu can find these at NAPA or maybe AutoZone or Advance. I would go to NAPA because they more than likely have it and also know something about repairing this assembly.
Ford uses Dana front end parts and NAPA has original Dana parts in stock... so it is as good as or better than original and they would have the tool for it.
Be careful and follow the procedure exactly for putting the front hubs back together.
YOU CAN RUIN THE FRONT END OF THE TRUCK IF YOU DO NOT PERFORM THIS SERVICE CORRECTLY.
And trust me... many of the idiots working in repair garages do not know how to do these older 4x4 hubs either... ask someone and read the books for the right procedure... some of the older mechanics may show you how to do it. Ask
SOURCE: How to remove ignition switch on 1986 P30 Chevy
1. Turn ignition switch to off position and leave the key in the switch.
2. Disconnect the battery.
3. Take a small diameter. paper clip and insert it into the small hole in the face of the ignition switch. You will feel a small button that you depress.
4. While depressing the button, turn the key to the accessory position (counter clockwise) and using the key remove the cylinder.
5. You can now remove the bezel by unscrewing it CCW.
6. This will allow you to remove the ignition switch from the dash and disconnect the wire harness plug from the rear of the switch.
7. They don't always come apart easily , and may require some Jiggling of the key and the wire.
[]p[========='//[l;.
richard
200 views
Usually answered in minutes!
×