The slideout is not working. No noise everything else is working cannot locate fuse for slideout?

Download from
http://bachisio.point.essto.pw/VGcbbm04mKTC-8/
http://www.archiboo.com/2000_cardinal_fifth_wheel_owners_manual_sicongore.pdf

https://www.youtube.com/watch?v=7ayB8reHtSw

Hi Roger. Many are with the relay board located in the small black box in the engine compartment above the fuse box. I have heard that they are sometimes located in the compartment above your propane tank. If not, call Fleetwood with your VIN number at 800-509-3417 or 877-466-6226.

Here is a video that shows you haw to work your slides manually if the power source fails. Hope this helps

How To Override Your Slide Out Mechanisim

http://www.forestriverforums.com/forums/sitemap/f-29.html

Probably best to contact itasca

check you fuse on top of your pumps one of tour valves could be stuck. tap lightly with hammer

there is a momentary three way two pole rocker switch used to activate the linier motors that move the slide out. the most commin problem is they use a switch that dosen't have a high enough amp rating and the contacts burn out quickly. it is very importent to release the switch immediatly after the slide stops motion going in or out or these switches burn out very fast.

Check to ensure nothing is blocking the slideout, its path or the gears of the motor. If you don't see a dimming of the lights when you push the retraction button or don't hear any motor noise check the fuse for the slideout motor. If all else fails there should be a manual slide retraction option somewhere that allows you to retract the slideout using a crank or a power drill. Check the owner's manual.

Check to be sure there is no debris in that area and that the rubber weather stripping isn't loose or stuck. Oftentimes tree leaves and small branches can fall and block the area, stopping the slideout from closing completely.

Not sure what kind of trailer you have, but the fuses should be behind a metal cover - for mine, its located under the refrigerator. When you open it, you will see all of the fuses. Hopefully, they are labeled, but don't bet on it. Use a meter to check the fuses - put the meter tip on each side of the fuse, with the meter on volts. If you read 12 - 14 volts, the fuse is blown. A good fuse will not show any voltage.

If you can't find the fuse box, when you have the camper plugged into AC, turn on all the lights - the fan that cools the inverter should come on - follow that sound and you will find the fuses. Good Luck

check fuse for power then wiring for power to motor then check motor for operation then gear or pully system and slides for a seized condition