Keystone 2008 Hideout 30SRS Logo

Related Topics:

A
Anonymous Posted on Feb 13, 2014

How do you get in top bunk of keystone hideout

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2helpful
1answer

Where is water pump on 39 ft keystone hideout 2017

nearest to the water heater, on inside there may be a wood panel with 2 screws securing it, which will gain you access to it
Oct 24, 2019 • RVs
0helpful
1answer

Need the manuel for 2015 keystone hideout

Contact your local retailer directly or online here:
http://www.keystonerv.com/contact-us
Feb 09, 2017 • RVs
0helpful
1answer

Location of manual overide slide

Mine is located underneath of the slide. If you lol through the back wheelwell you should see a black rod. My camper came with a manual crank rod. Not really sure if you could use anything else...it's a lot of cranking
0helpful
1answer

Where is the furnace breaker

Is the pilot light lit? There should be a valve that turns the gas off at the furnace itself. This valve is for the pilot lite There is no breaker of sorts but rather a sparker that lights the furnace. If the furnace does not light there is a small 12 volt valve that shuts off the gas to the furnace but not to the pilot light. Also make sure your 12 volt system is connected and operating. It wont work without it as it operates off that system not 120V. The same goes for refrigerators, the will not function with the 12v system disconnected
0helpful
1answer

Running lights

Brake lights and running lights are on different wires with power being supplied through the 7pin connector between the tow vehicle and the trailer. Under the tongue there is usually a junction box that the "pigtail" is wire through and the lights are wired in at that location.
0helpful
1answer

Keystone hideout 28BHSE

There are more than likely two struts holding the bed up. Applying weight (your body weight) should push the bed back down. If not you may need to disconnect the bed struts. To do so you will need a flat tip screwdriver. On the back of the plastic head on each end of the strut you will see a metal clip wrapping around it. There will be a small slot to insert a screwdriver and pop the clip loose. This will allow you to remove the strut. Be careful because the bed is heavier that you may think.
Mar 16, 2014 • RVs
Not finding what you are looking for?

156 views

Ask a Question

Usually answered in minutes!

Top Keystone RVs Experts

David Spradling
David Spradling

Level 3 Expert

13520 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66761 Answers

goneforever.

Level 3 Expert

14531 Answers

Are you a Keystone RVs Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...