20 Most Recent Jayco 2013 Jay Flight Swift 264BH Questions & Answers


120-
VOLT
AC
SYSTEM
The following electrical components (if so equipped) will only operate when your
RV is connected to shore power: 120 to
12-volt power converter, air conditioner,
120-volt refrigerator, microwave oven, television(s), fireplace and appliances
plugged into convenience receptacles.

SECTION 6 - ELECTRICAL SYSTEM JAYCO TOWABLE
6-2
120-
VOLT
CIRCUIT
BREAKERS
The 120-volt AC circuit breakers located in
side the main load center protect all
120-volt wiring and components in the RV fr
om circuit overloads and short circuits.
Should a circuit overload or short circui
t occur the circuit breaker protecting the
affected circuit will "trip" preventing the flow of electricity through that circuit.
If a circuit breaker trips, shut "off"
the appliance on that circuit (i.e., power
converter etc.) and allow the circuit breaker to cool down for a brief period of time.
After the cooling down period, reset the circuit breaker by moving its lever "off" and
then back to the "on" position. If the circuit breaker re-trips or frequently trips,
contact your dealer to have the electrical problem diagnosed and repaired.
A circuit breaker identification label is permanently attached to the inside surface
of the 120-volt load center.
Maintenance and Replacement
At the beginning of camping season, inspect the circuit breakers and replace as
needed. Test by turning each circuit breaker "off" and back "on". Circuit breakers
are wearable parts and must be replaced
as needed, as part of your RV
maintenance. If you have any questions, consult your dealer.
Please contact your dealer for repair assistance when replacing circuit breakers.
CONVERTER
The power converter converts 120-volt AC power to useable 12-volt DC power
when the shore power cord is connected to an external power source.
The converter has a built-in protective thermal breaker that will shut it down should
overheating occur. Overheating can be
caused by operating the converter above
its maximum power output for an extended period of time, or by an obstruction to
its ventilation air flow. To reduce converter heat build keep unnecessary 12-volt
lights and motors turned "off"
.
Keep the converter cooling fins and fan clear of
obstructions.
Inspection and maintenance
If the 12-volt power converter is not working (auxiliary battery not being charged)
check the reverse polarity fuse(s) in the converter fuse panel.
There are no
customer serviceable parts inside the converter case and the
manufacturer's warranty will be void if
the case has been removed
. If you
have further concerns contact your dealer.

Jayco 2013 Jay... | Answered on Feb 06, 2018


Sounds to me like your break-away key has pulled out! Make sure your break-away key is FULLY IN PLACE, and that the break-away switch hasn't simply failed.

Jayco 2013 Jay... | Answered on May 12, 2015


check to see if setiment has settled on the pilot....blow it out with air if it has. This issue comes up often with water heaters and rv refers. If that is not the problem and the pilot remains lit, but never increases when the thermostat is turned up, you probably need a new gas valve/thermostat.

Jayco RVs | Answered on Jul 13, 2019


If you're having issues with the slide mechanism, figure out the manufacturer of the slide and Google it for a troubleshooting guide and repair manual. Their website will often have instructions for manual retraction or extension.

RVs | Answered on Nov 07, 2019


Contact the manufacturer/distributor directly to request the manual.

RVs | Answered on Nov 04, 2019


I can only suggest to try a dealer....EBAY...Amazon or even try Craigslist. Surely someone has one. Good Luck!

RVs | Answered on Nov 02, 2019


I would start by checking your 12 volt battery voltage, should be 12.5 to 12.8 voltage reading, as with out it the heater will run briefly and then shut down. There are many factory trouble shooting guides on line for free. Not sure if you have a ATWOOD Suburban heater?
Normally if the fan motor comes on... it blows against a flat plate called a flail switch. That switch tells the ignition device to give spark to the GAS CHAMBER. So my guess is....with your start stop condition....the the electronic control is not working correctly due to low battery voltage. As you said....when on 120 volts going to the 12volt invertor...things work correctly. Lots of information on U-Tube on furnace troubleshooting! Good Luck Goodn

RVs | Answered on Nov 02, 2019


Contact Komfort directly to request the manual.

RVs | Answered on Oct 28, 2019


usually close to the storage tank

RVs | Answered on Oct 25, 2019


should be on tag on front side of driver side

RVs | Answered on Oct 22, 2019


There are quite a few manual websites out there -- not knowing the model is a challenge. Hopefully this link will continue to work for a while:

https://www.gocaravanning.com/caravan-specs/Sprite-Caravan-Data.html

RVs | Answered on Oct 20, 2019


The question doesn't have a lot of detail -- model of RV, which slide out if more than one, what kind of cable?

Generally, if it is a power cable, disconnect from shore power and disconnect both the cabin battery(ies) and the engine battery(ies). Find the end of the cable (fuse panel, switch) and disconnect unless there is a junction or connector that is easier to access. Carefully unmount any cable ties or holds/clamps to free the cable. Reroute to your preferred location, clamp in place. Things to consider: is rerouting necessary? Will there be enough slack in the cable to operate when the slide out is extended, or doesn't k*1*n*k, pinch or droop below the chassis when slide out is retracted. Any sharp corners or wear points it will rub against? If replacing with a new cable, is the cable suitable for exterior environments if it is outside/underneath -- and if it is power, is it sufficient gauge for the power running through it?

You can probably see why it's hard to answer your question -- many variables and unknowns. Can't believe k*1*n*k is a naughty word on this forum.

RVs | Answered on Oct 20, 2019


manually move all jacks at least 6 inches then retract all if possible raise or lower front pins possible out of stroke then level manually once level turn off panel press up button 7 times then down button 7 times the panel will come on and ask if unit is level if yes press enter then lower front a little manually then try auto level

RVs | Answered on Oct 19, 2019


if not in compartment where water inlets city and tank fill if no heater bypass valve then behind waterheater

RVs | Answered on Oct 16, 2019

Not finding what you are looking for?
Jayco 2013 Jay Flight Swift 264BH Logo

Popular Tags

2 questions posted

Ask a Question

Usually answered in minutes!

Top Jayco RVs Experts

Lawrence Oravetz

Level 3 Expert

10543 Answers

Ken Strite
Ken Strite

Level 2 Expert

104 Answers

ray gallant
ray gallant

Level 3 Expert

65332 Answers

Are you a Jayco RVs Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Jay Flight Swift 264BH Jayco

  • Jay Flight Swift 264BH Jayco

Most Popular Question

outlets not working all fuses good

  • RVs
Loading...