SOURCE: battery location for a 2004 suzuki intruder 800
Hi ...... Find where the battery is, under the seat or behind a side panel. Disconnect the black (negative lead usually with a 10mm spanner then disconect the red (positive) lead. The battery will be held in place with a 'rubber' strap or a bracket and depending on type of battery there may be a vent hose from the battery to the lower half of the bike, this just pulls off and remains in place until you replace the battery. Installation is reverse except you connect red (positive) first.
Let us know how you get on.
SOURCE: Exhaust Pipes on 1995 Suzuki Intruder VS
Hi Lcyr.
Any changes you make to the exhaust system will alter the sound the bike produces. The more you cut baffles,and open up the exhaust, the louder it will get. What you do alter to a greater extent,is the state of tune of the motorcycle. Any changes to exhaust or inlet plumbing will require a retune of the engine to suit the modifications. This can be subtle to dramatic. Opening up exhausts can often rob low end power where exhaust port scavaging is relient on some back pressure for maximum effect.
Best to work directly with an engine tuner to do the mods that are known you can get away with, or buy aftermarket prebuilt pipes that have a known previously tested state of tune. Nothing worse than doing something, that then costs money to put back the way it was on finding out it didnt work as well as was hoped.. Hope this has helped you steer your custom mods a little. I can say with certainty, that I have ventured to do what you are doing many times in the past, and it has always cost me more money in tuning and... and well more parts :) Cheers
regards
robotek
SOURCE: battery removel for a 2004 suzuki 800 intruder
the battery is under the bike, bottom of box hinges down, just in front of rear wheel.
pain in the ***
some recomend parking bike wheels and kickstand on board for better access.
SOURCE: battery removel for a 2004 suzuki 800 intruder
I know for the models till 2002 where the battery is located in front of the rear wheel.
Place the bike on her side stand
remove the negative battery lead at the left side, just below the transmission tube ( cone ) 10mm socket wrench
On the right side remove the security cap on the positive lead ( cross screwdriver ), then remove the positive lead.
The battery is hold in place with a 'floor plate'. remove both bolts of the floorplate ( on each side ) while holding the palte into place.
gently lower the plate and the battery.
I hope the 2004 model has the same assembly!
SOURCE: i got to the battery
Unfortunatley the battery will not just fall out when the floor plate is unbolted. The battery is larger than the clearance. The bike needs to be elevated from the rear to access it. The best way is with a motorcycle jack.
269 views
Usually answered in minutes!
×