To change the choke cable, you must take the carb off the engine. Remove the air filter and backing plate. Take the nut off the backside of the choke cable and let the cable come out of the bracket that holds it. Make sure the petcock is turned off and disconnect the fuel hose at the carb. Loosen the throttle and idle cable at the handlebar throttle assembly. Pull the carb out of the intake manifold seal. Work the throttle and idle cables out of their positions in the carb. Bring the carb with the choke cable out and away from the engine. Take the choke cable out of the carb with a 14mm open end wrench. Take the plunger and spring off the old cable and swap it to the new cable and reinstall the choke cable. Put the throttle and idle cables back onto the carb, put a new intake manifold seal on the intake manifold and push the carburetor back into the new seal. Put the choke cable in it's bracket and secure the nut. Be careful and do not over tighten the nut as the plastic cable housing will break. Reconnect the fuel line, the vacuum line, and anything else that was taken off. Replace the air filter backing plate and the air cleaner. Readjust the throttle and idle cables making sure that the throttle operates freely and returns when let go on it's own. Never put any kind of lubricant on the choke cable. There is a knurled wheel that you can use to tighten the cable so that it stays where you put it.
Ride Safe
Steve
594 views
Usually answered in minutes!
×