What is the corrrect premix ??? in mililitres to one litre of petrol????????? thanks joe

The light is not due to any clogged filter issue, you have an engine fault in one of the sensors most likely.

50 litres petrol:1 litre Outboard TCW3 OIl
100litres petrol:1 litre Outboard TCW3
@ 50:1 You Would Put 240Mls Oil In 12 Litres Petrol
@ 100:1 You Woul Put 120Mls Oil In 12 Litres Petrol

hi artwill3544

no

using sthil 2 stroke oil mix at the rate of 50:1 that is 20 mils of oil per 1.0 litre of petrol that you mix , or if you mix 5 litres you would pour in 100 mils of 2 stroke oil into a 5 litre petrol petrol can , then add 5 litres of petrol only and give good shake to mix , then fill your blower with that mix

cheers pauly46

ushally 50:1

husqvarna 142 e will use 91 octane fuel is ok and use qood quality 2 stroke oil
at the ratio of 50:1 premix that is 20 mils of 2 stroke oil for 1 litre of petrol that you mix

so if you want to make a 4 ltre mix add 80 mils of 2stroke oil to clean container and add 4 litres of petrol only and give good shake then fill saw


cheers hope it helps


pauly46

change the plugs and the air filter &try not to speed, that always consomes more fuel. if that dont help, change the plug wires

Hi and welcome to FixYa, I am Kelly

First off the engine is designed to operate on unleaded fuel. The manufacturer makes no statements at all about E-10 Fuel. I will tell you from experience that you can use E-10 Fuel but.... should you ever have a warranty claim make sure the entire fuel system is 100% unleaded pre-mixed fuel. Your not going to hurt the unit using E-10 fuel as long as you maintain the proper fuel-oil mixtures. If anything a splash more of 2 stroke oil as in 22 mm / liter vs 20 mm. Or (+) 8 mm per gal.

Manufacturers statemenrts and recommended fuel mixtures below:

Thanks for choosing FixYa,
Kelly

n This product is powered by a 2-stroke engine and

requires pre-mixed petrol and 2-stroke lubricant . Premix

unleaded petrol and 2-stroke engine lubricant in

a clean container approved for petrol.

n This engine is certified to operate on unleaded petrol

intended for automotive use with an octane rating
of 87 ([R + M] / 2) or higher.

1 Litre + 2 0 ml =

2 Litres + 4 0 ml =

3 Litres + 60 ml = 50:1 (2%)

4 Litres + 80 ml =
5 Litres + 100 ml =

The full operators manual is here:
http://www.screwfix.com/sfd/i/cat/pdfs/89/p4763889.pdf

if using top quality 2 stroke oil

you put 100 mils of oil into 5 litre container and add 5 litres of fuel only that is 50:1 petrol oil ratio

cheers pauly46

HTE RM'S ARE GREAT BIKES CHECK WITH A DEALER, I THINK THEY WILL TELL YOU TO USE A SYNTHETIC OIL BUT THE MIX IS 32-1

The vehicle has a belt and should be changed every 60,000 miles.