I have a motorhome on an Iveco Daily 50C 18 chassis 2006. The factory fitted trailer 13 pin socket is dead. I have checked all the fuses and cable, and even spoken to Iveco on the phone on what to check with no joy. The loom runs from the socket, forward to under the bonnet, where I suspect it goes into some sort of ECU. I am unable to find any wiring diagram, so don't know where or what I'm looking for. Any help would be much appreciated. Regards, John.

SOURCE: 1996 Dodge Ram Factory Trailer Wiring Schematic

all you need is a cheap continuity tester, any one to help tap on the brakes..7pin is just like the 4 pin w/extra power wire for acc.lites,electric brakes.when you buy the 7pin rec.,comes w/wiring schematic standard to all trailer rec.- you can do it..kev-mn.

SOURCE: Fitting a towbar for a caravan with 13pin europlug

black socket, black 7 core wire
pin 1 yellow left indicator
pin 2 blue, rear fog light
pin 3 white earth
pin 4 green right indicator
pin 5 brown right side/tail light
pin 6 red brake lights
pin 7 black left side/tail light

Grey socket grey 7 core wiring
pin 1 yellow, reverse
pin 2 blue, supplementary feed (ignition)
pin 3 white, earth
pin 4 green live feed (battery +)
pin 5 brown not connected
pin 6 red supplementary feed (ignition)
Pin 7 black earth

On the discovery there is a purpose made plug behind the panel on the drivers side rear, behind the rear lamp
i think the relay you have bought is for lamp failure you just need a normal 4 pin 30 amp relay.
Good luck Davelee

SOURCE: my tom tom one has no sound

Hi! Check your chosen voices and test it! Choose another voice and test it again, if still not working then is a hardware problem... My email is [email protected]

SOURCE: hi need to get hold of a diagram of fuse box with

try these websites www.alldatadiy.com and if you do not have an owner manual give this website a try to see if you can download one for your car its www.edmunds.com wish you the best of luck Michigan Man

SOURCE: Tow bar trailer socket wiring connection point to car wiring?

The connectors for towing wire harnesses on foresters are generally on the passenger side, below the rear taillight inside the cargo space. some require pulling up the foam block that is between the spare tire compartment and the taillight. Check where you replace the tailights from inside the car, if there isn't a matching connector hanging out there, check around the spare tire compartment, see if you can remove the carpeted foam block next to the compartment and find the plug under there.