I want purchase Yamaha yzf R15 2nd hand

SOURCE: changing yzf r1 frame

you wont get one, you just have to figure it out as you go. start by stripping all your bodywork off and removing the engine, then the front forks rear wheel and wiring harness. then replace it all on your new frame. keep your work area clean and tidy, mark all electrical connections you have to undo with tape and write on it where they re-connect to.
good luck

gavin jones

• 1508 Answers
• Posted on Apr 05, 2010

SOURCE: yamaha yzf 450 2005 model

5 gears

SOURCE: My 2000 yamaha yzf and sometimes when i shift from

I had a Kawasaki where if you pressed the gear shift halfway down in either 1st or 2nd it sent it to neutral.Maybe you're just not pressing hard enough to shift?Please let me know whether that is it or not and we'll see what we can do.Thanks and good luck!

SOURCE: 1999 YZF-R6: Yamaha YZF-R6 1999 Clutch feels very stiff. Does t...

THE OPERATION OF THE CLUTH ON HIS MODEL IS OF CABLE TYPE, IF THE CLUTCH IS OPPERATING CORRECTLY THE 1ST THING TO CHECK WOULD BE THE CABLE, REMOVE THE CABLE YOU SHOULD BE ABLE TO PULL THE INNER WIRE SMOOTHLY TO AND FRO, IF YOU NEED TO USE ALOT OF EFORT TO DO THIS THEN YOU WILL NEED TO REPLACE THE CABLE,MAKING SURE YOU HAVE ADEQUIT FREE PLAY AT THE LEVER WHEN RE FITTED. OBSERVE THE ROUTE THE CABLE TAKES BEFORE REMOVAL AND REPLACE IN THE SAME WAY, YOU MAY ALSO TRY TO GET SOME LITE OIL DOWN THE CABLE, THOUGH I SUSPECT THIS WILL BE ALMOST INPOSSIBLE IF IT IS THIS TIGHT TO OPPERATE

SOURCE: i have a 1997 yamaha yzf 600 and it wont go in 1st

1. How old is the clutch pack, if more than 2 years, have it checked out.
2. Clutch travel or fork may need some adjustment.
Cheers