2006 Yamaha Stratoliner engine backfires when shifting gears

Gino Cussen

• 217 Answers
• Posted on Mar 21, 2009

SOURCE: 1997 Yamaha FZR 600 cuts out when shift into first gear

Does the bike have a sidestand switch that cuts the power if the stand is left down? If it does, disconnect it and temporarily join the ends together and try starting....

SOURCE: I can't shift out of first gear.

You have a bent shift fork. The repair means taking the engine out of the frame then removing the top end, removing the flywheel and electrics, removing the clutch , shift mechanism and kick starter and a few other parts. THEN you are ready to split the gearbox to remove the crankshaft and then the bent shift fork. Next you get to put it all back together. This is a pretty big job for the home mechanic.

You will need an impact driver, flywheel puller, case splitter and torque wrench plus the normal screwdriver, pliers, etc.. Alternate to the special tools is taking it to the dealer and say "Fix it".
I normally tell people to take it to the shop just so they don't get into such an involved project.

Please rate this solution. Thanks cindi866!

SOURCE: Backfire

ya u got a exhust leak

SOURCE: tire pressure for stratoliner

For riding 2 up I recommend 38 front and 42 rear. Some riders have commented on some front wobble corrected by putting the front to 40 psi.

SOURCE: my 2006 yamaha stratoliner has

The valve clearance is automatically adjusted be the hydraulic valve lifter. However Yamaha say there are times when the valve clearance needs to be adjusted manually. Basically to balance a pair of valves if they become misaligned (pretty dam rare) as they are operated by the one lifter. (eg Inlet pair has one hydraulic lifter and the Exhaust pair has one hydraulic lifter)

The recommend service / checking interval is 20,000 kms. (12,000miles approx) according to the manual.

I have 15800 miles on my 2008 and after speaking with a Yamaha service technician, he hasn't had one in yet that has required adjusting when he has carried out the 20,000km service. Infact he has had to adjust one as of yet even at 40,000kms.

It is a bit of a pain to do, as a lot of stuff has to be removed and the covers are a little tricky to get off.

Me, I am not going to bother until 24,000miles, as long as you change the oil and filter every 5000 miles my Yamaha guy recon it will be OK.

If you are going to do it yourself, you will need a manual as only one value has an adjuster and the other is a slipper, so they are not as easy to adjust as a pair of standard valves.