Will a 2004 suzuki rm 250 front brake line fit on a 2003 suzuki rm 250

the only thing that is ajustable on the rear brake is the pedal eight ajustement closed to the master cylinder itself...if there is problem braking you may have inside cup done or air in the circuit due to low level or brake line done.....hope this help!

use the correct poss ion to fut fork oil........ and you should be drain new oil and them drain off the old oil

I believe you mean the clips that keep the brake pads from rattling.
The smaller one of the two, fits into the caliper where the front of the pads slide into the caliper. It goes between the pads and caliper, and has a slot to where the disc fits. It kinda fits into a recessed rectangle hole. (Opposite the brake pad pin.)
The longer clip has two small tabs on it's back, near the center, that clips towards the top center of the caliper, and it puts pressure downward on the pads. One end rests on the top of the pads, as the other ends up resting on the "pin" that holds the pads in place.
Look close, and you should see marks where they were, as they can only go on one correct way.
Good luck!

2001- 2006 rm125 and 2001- 2006 rm and rmz 250 about $50.00 for new,should find a used one on ebay

210 mm from the top of the leg with the fork fully compressed and the springs removed. That's 8.25 inches