How do i take off the stator
SOURCE: changing yzf r1 frame
you wont get one, you just have to figure it out as you go. start by stripping all your bodywork off and removing the engine, then the front forks rear wheel and wiring harness. then replace it all on your new frame. keep your work area clean and tidy, mark all electrical connections you have to undo with tape and write on it where they re-connect to.
good luck
SOURCE: how to remove a stator pully for a 2003 yamaha r1
HEY BUD, THERE IS ONLY ONE WAY TO PULL THE STATOR ALL BIKE COMPANIES MAKE A PULLER JUST FOR THIS PURPOSE. YOU SHOULD INVEST IN ONE THEY ONLY COST 20 TO 30 DOLLARS AND IS A LOT CHEAPER THEN THE STATOR IF TRIED ANY OTHER WAY
Testimonial: "thank you do u know where i can get that tool "
SOURCE: i need a repair manual for a Yamaha 2003 R1
Bike bandit .com is as cheap as anybody if your going to buy one and looking at their parts breakdowns may tell you what you need to know it the exploded veiws of the parts.
SOURCE: 2003 Yamaha R1... Replaced the
ill bet you have a alternator that is grounded out not so much the armature
the archer witch is the out side peace more than likely on the passenger side
you can see it thrue the side cover i will try to find a pic
355 views
Usually answered in minutes!
×