How do I split the cases on 2002 Honda CR 125

SOURCE: 2001 cr 125 idling way to fast

i found the problem it was the adjuster at the throttle that had been tightened by one of the kids i loosened it off and it now runs better than it ever did thanks for your help and suggestions and qwick response

SOURCE: GAS MIXTURE CR 125

i would mix it 50/1 it will make your bike run a whole lot better

SOURCE: Engine compression for 2002 125 CR Honda, 125lbs?

that sounds pretty decent, it is 7 years old so there will be less compression now than when new, obviously beacuse of wear. but 125lbs is good.

SOURCE: i bought a 2001 cr 125 with the wiring all cut.

1) Purchase a shop manual from a dealer. Inside will be a wire diagram scamatic that will show color codes and ohms resistances. Test all electrical components with ohms meter to varify working properly. If factory conects to electrical componets are there then **** end connect back in place using correct color codes from manual. 2) If factory connects are missing you will be better off buying a new wireing harness for the bike via dealership. The last is going to be your best solution since all you will have to do is plug everything back in where it goes. Most connections will only reach as far as the item it is supposed to be pluged into and will only fit one way or the one particular item. It is always a good idea to buy the shop manual for future issues.

SOURCE: Honda CR 125 1997 wont idle

Your carberautor is either gummed up or needs to be adjusted. Begin by going to an auto zone or similar store and gatting a can of carb. cleaner that gets added to your gas. Be sure to follow the instructions on how much you add per gallon. let that run through your bike for a while and see where you are. If cleaning the carb. doesn't hellp, then the carb. will have to be adjusted.