SOURCE: oil required for 2001 yamaha R6
I would go with a full syn since you're tracking it. Costs a bit more but its worth the protection. Personally I like Motul Full Syn, but most will do what you need. Check to see if the Mfg has a preferred oil brand, Factory Yamalube might be what you need. Cheers mate.
SOURCE: '95 Yamaha YZ 125 clutch - stays in gear when clutch is pulled in
hey dude,, just thought id come in and give u some tips or 3,, i take it when u pull clutch lever in, and try and change gear it feels like your foot will snap b4 it goes in gear,, if that makes sense,, firstly mate,is to make sure the clutch cable slides freely ,easest way is to take cable off and just grab 1 end and make sure it isnt sticky,, if so dip one end of the cable in a bit of old oil ,,whilst holdin the other end ,pull and push the cable inner, this will **** up a bit of lubricant inside the cable ,, keep doin this each end till free to move, ,,next step if the cables ok,,, and may need help if u dont no,drain the oil out,,and as u r sat on the bike is to remove the clutch casing on the right hand side of the moter,where the bottom end of the cable goes,remove the casing being carefull not damage the gasket,,then u will see clutch plates and friction plates housed,, undo the 7 or 8 spring loaded bolts carefully take the first fibre plate out then metal friction plate then another fibre plate and so on,, wen u take the 1st plate out place that on the bench ,stacking each plate on top of one another, cause they have to go back in as they came out,,wen out,,u need a piece of wet n dry paper ,or fine emery,,and just wipe round both sides of the fibre plates taking the shine off them,as u put them back in,, put casing back on with a decent gasket,, oil back in cable on, make sure cable has no free play on the lever so wen u r about to pull lever in it bite straight away,, start her up, warm it up and try it,,any probs still il eat my shoe,, take care m8
SOURCE: Engine noise after parking under the sun!!
Sounds like the tank isn't venting properly. Next time you hear the hiss, try opening the gas cap. If that makes it stop, it should also drop the idle speed. If so, you need to pull the tank and make sure the tank vent hose isn't pinched.
SOURCE: I need to clean the carb of my Yamaha TZR 50
Your carb is situated under your petrol tank, It is possible to take it off buy taking your tank off (just make sure you turn the petrol tap off first) then unbolting the air intake plastic thing (big black thing under your tank) sorry dont know what its called, then you will have your carb, just make sure you take pics of where the tubes and wires go before taking it off. Hope this helps
SOURCE: sir, im having yamaha fz16 bike... the
notin can be done dude.. its a major fault u can see in all FZ's.. My engine smelled really bad in 1st two days...
Yamaha has announced the price for the YZF- R15 today, and its going to cost Rs 97,425 ex-showroom price all over India.
More details on the R15 can be found here-
http://turbocharged.wordpress.com/2008/06/12/yamaha-r15-launched-specifications-details/
Source:http://economictimes.indiatimes.com/News/News_By_Industry/Auto/Two-wheelers/Yamaha_launches_150_cc_sports_bike/articleshow/3123551.cms
Hope this help ;-)
58 views
Usually answered in minutes!
×