Question about 2007 Suzuki DR-Z 400 SM

1 Answer

Fokr oil for a dzr 400sm 08 amont - 2007 Suzuki DR-Z 400 SM

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,512 Answers

G'Day ivan,

Fork oil capacity, per leg 182 mL (6.15 US oz) inner rod
350 mL (11.8 US oz) outer tube ------

regards robotek

Posted on Apr 09, 2010

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Plugs fouled


there are two ways plugs foul up is too much fuel or oil is getting in to the cylinders,does the bike blow excesive amont of smoke on start up and when you are riding,and is it one spark plug or all if it is a single plug and comes out black with oil then it could be a vave seal or it could be a damaged oil ring on your piston ,if it is doing it on all cylinders then more than likely the piston and rings need replacing and the bores to be honed or rebored to the next size piston and rings,hope tis helps cheers pete

Sep 10, 2013 | Suzuki VS 1400 Intruder Motorcycles

1 Answer

Where is the Orifice Tube on a 1998 Ford Escort, and of oil it take amont to put back in


you must replace the line going into the fire wall. this is a fixed orfice system. small line is were you will see an compression crimp. this is your orfice.

Aug 09, 2011 | 1998 Ford Escort

1 Answer

After running for a few hours it gets hot and shuts down but runs fine every morning


Without more info I will have to give you several things to look at. Typically during the hot months rotary units experience temperature shut downs due to the following. Dirty oil coolers. Blowing them out with air my help some but ideally they need to be washed using a degreaser solution. Location. during the hot months poor air flow/ air removal may let heat from the compressor build up in or under the cover or room. This hot air gets drawn in by the compressor and raises the compressor temperature. The cycle continues until the compressor shuts down on high air temp. Maintenance. Poor maintenance on rotary screw compressors leads to shut downs on high temp, high air temps then play havoc on dryers which causes moisture in the air system. Maintenance items that need replacing regularly ( about 2000 hrs) oil filter, air filter, Depending on type of oil used change 2000 to 8000 hrs, seperator @ 8000 hrs. Also the amont element will cause high temps if bad. It is located where the three oil lines come together. There should be 4 screws that hold the cover on. the cover also has a hose connected to it and located close to the oil cooler. This amont element acts like the thermostat in your car. it lets oil bypass the oil cooler or causes more oil to go thru the cooler. the cooler oil and bypass oil mixes and maintains a certain temp. air end temp should run about 195 F and injected temp about 165 F. hope this helps. if you can give more detailed info I can get you closer to your problem.

Jul 13, 2011 | Air Tools & Compressors

1 Answer

Oil light is on


check oil could be low if low add proper amont of oil till up to full mark on dip stck. if light goes off thats problem. if still on with oil full could be sensor

Dec 23, 2010 | 2003 Chrysler Town & Country

1 Answer

I have a 1993 Plymouth laser and have never changed oil before, but watched, not sure what to do.


Remove drain plug from oil pan to drain oil. Remove oil filter using filer wrench. Instatt new oil filter. Put oil drain plug back in. Check owner's manual for oil capacity, put all oil in minus one quart. Start engine let run for aproximately 10 seconds. put in rest of oil and check dip stick to ensure corret amont.

Oct 09, 2009 | 1993 Plymouth Laser

1 Answer

What is the engine oil capacity for the 1993 Honda CR250


i dont know the exact amont but in your righside of your engine theres a window glass put oil up to the middle of the windows.

Aug 07, 2009 | Honda CR 250 R Motorcycles

1 Answer

110cc blowin smoke


the engines getting hot you need the right amont of oil to cool the engine , it has to b the rite oil too,go to your loacal bike shop and tell them your bike details,ok

Mar 29, 2009 | Pit SSR 110CC Pro Beginner Bike

1 Answer

Leaking oil


You must first clean the under carriage very good with a steam cleaner preferably. Then lift up in air let run and you will find leak.

Jan 04, 2009 | 1990 Nissan 300ZX

Not finding what you are looking for?
2007 Suzuki DR-Z 400 SM Logo

Related Topics:

211 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

6103 Answers

ROB

Level 3 Expert

858 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...