Torque specs for the clutch bolts on a 2002 cr125 and clutch cover bolts
SOURCE: Engine compression for 2002 125 CR Honda, 125lbs?
that sounds pretty decent, it is 7 years old so there will be less compression now than when new, obviously beacuse of wear. but 125lbs is good.
SOURCE: torque specs for cam on 2006 honda crf250r
Rock the caps around to make sure the bearing locating clips are lined up. Torque the bearing caps to 12 foot-pounds. At this point you must check the valve clearances again. If any are off, the cam must be removed and the correct shims installed.
Please rate this solution. Thanks!
SOURCE: Honda CR125
Go to this websit and select discuss this bike: http://www.bikez.com/motorcycles/honda_cr_125_r_2006.php
SOURCE: Problems with the clutch
The gear changing problem is going to be a bent shift fork. Is it stuck in 1st gear, 2nd gear? Those are the most common. As far as the engine quitting, I don't yet have enough information to give a suggestion on why it is happening. It could be a bad kill switch, plugged fuel filter or vent, water in the gas, carb needs cleaning or . . . A bunch of possible causes. Which one depends on how the bike has been acting lately.
SOURCE: i have a 98 cr250r and i just swapped the clutch
Convert to other measurement standards at the site below.
http://www.online-utility.org/measures/torque_measurement_units.jsp
1,245 views
Usually answered in minutes!
×