How do I install battery for 2001 harley sportster 883

SOURCE: I have Harley Davidson 2000 Sportster 883. I

Your key switch could be bad or you have a broken power wire from the battery to the circuit breakers. Check everything with a voltmeter.

SOURCE: how to drain oil from 2001 harley sportster

The drain hose comes down the back of the frame and looks like it attaches to the frame.

SOURCE: harley sportster clutch

You just need to adjust your clutch cable.

SOURCE: 2007 harley davidson xl sportster 883 speedometer

If you're lucky it might be the speed sensor located in the gearbox casing. This is a hall effect device and is magnetic and so can pick up metal fragments from the inside of the gearbox. I have a 2001 Sportster and the Sensor is located on the top of the gearbox casing, just below the starter. I'd expect it to be in a similar position on a later bike such as yours, but I can't be sure. Once you've located it, take it out (can be a bit fiddly) and make sure that its clear of any debris. If not the sensor, you're probably going to need to substitute in a working speedo. Be careful because a pre-2004 speedo is electronic, but is not compatible with 2007 bike. Best of luck!

SOURCE: how to change drive belt on harley sportster 883

Changing the drive belt on a Sporty is a snap compared to a big twin. First you'll have to remove the rear brake master cylinder and pedal or at least take the bolts out and move it out of the way. Remove the front pulley cover. Remove the rear wheel and the shock on the right hand side. You should be able to work the belt off the front pulley and get the new back on.

When you put the new belt on and tension it, make sure you keep the adjuster bolts of either side of the swingarm about the same length. This ensures that the rear wheel is aligned with the swingarm.