How to replace dashboard lights - 1993 Jeep Grand Cherokee

How to Replace an Instrument Panel Bulb - YouTube

? 14:56
https://www.youtube.com/watch?v=Rwj74yo2knY
Jun 15, 2013 - Uploaded by Schrodingers Box
Removal of an instrument panel cluster on 1996 Ford Ranger to... 1999 Ford Ranger: How to change dash board lights, walk through part 1 ...

How to Replace Dashboard Lights : Removing ... - YouTube

? 2:42
https://www.youtube.com/watch?v=zzxz7iG81kI
Sep 18, 2008 - Uploaded by expertvillage
Use socket wrench to loosen dashboard bolts. Learn about technique for installing dashboard lights in a 1996 Ford Explorerin this free auto repair series fr. ... do you need to remove the radio bezel to get to the clips?? will this ...

How to Replace Dashboard Lights : Removing ... - YouTube

? 2:30
https://www.youtube.com/watch?v=QJWoJ17liQI
Sep 18, 2008 - Uploaded by expertvillage

you will probably find it easier if you just take out the clocks and unplug the loom from them then its just twist and turn the bulb out find a replacement and hey presto

if all your dashboard lights are not working, locate the fuse box... one of its fuses might be busted. replace with the same ampere. ^_^

how about interior lights ? and backup lights are they working ? sometimes they are all on same fuse or relay

When the dashboard lights in your vehicle malfunction or cease to operate, the resulting effects can range from being a mere annoyance to posing a safety hazard. Locating the problem and finding a remedy is essential. To fix dashboard lights that won't light, follow these suggestions

Evaluate the problem methodically. Begin the process by trying the simplest of solutions first. Most vehicles have a dashboard lights control switch that will dim the dashboard lights, as well as turn them off. Check the control switch, which should be located on the console near the steering column, make sure its in the correct position to have the lights on.

Check the dashboard light fuse. A blown fuse can disable the vehicle's dashboard light. The fuse box may be under the hood, or on the floor, near the brake pedal, or there may be 2 fuse boxes in both places. Refer to the diagram on the fuse box cover to locate the correct fuse. Replace the dashboard light fuse if necessary.

If all of the above don't fix it, then replace your light switch.

Lights? more than one? It is extremely improbable that many lights burned at the same time. Jiggle the dashboard dimmer wheel (used for light attenuation adjustment) to see if the lights come back to life. Dimmers, being rheostats, have the nasty habit of burning spots, so they work only at a different location than the burnt spot. Many burnt dashboard lights might be an indication that they got too much voltage. ( Bad voltage regulator). Dashboard lights are placed in the rear of the assembly, and screw right into it. Dashboard must be taken out, and it isnt simple. Purchase a full set of dashboard lights at the car dealer before taking down the dashboard, because you dont want to find out that you dont have the proper bulbs, and the whole dashboard already disassembled.

replace the headlight switch

i´d say you missfitted the wearing sensors while changing the pad. they work that way, that when they get chassis contact, this triggers the dashboard light.

toyota have them they go in easy.

you can remove the cluster and buy the bulb separate as far as the brake light it is either the float is bad in the master cyl. or you have low frt brake pads