What is the factory settings on the car jets - 1996 Suzuki VS 1400 Intruder

What kind of saw is it???
on average low jet is about 1 1/2 turn counterclockwise out after bottoming out the jet slightly
high jet about 1 turn counterclockwise after bottoming jet out clockwise

hope this helps getting your saw going

Resetting the Printer to Factory Default

Settings

Resetting the printer to factory default settings can be useful when

you are troubleshooting with the printer.

CAUTION Resetting factory defaults clears the page buffer, removes downloaded

fonts and macros, and returns all print menu settings to factory defaults.

To reset the printer to factory default settings

1 Press MENU until RESETS MENU displays.

2 Press ITEM until RESTORE FACTORY SETTINGS displays.

3 Press SELECT until the following message appears:

RESTORING

FACTORY SETTINGS

This message displays until the printer has completed the
initialization

basic settings for this saw would be one turn out on both screws, these are base settings so fine adjustment would have to be done, it it will not run at these settings there is somthing else wrong with it.

Generally all carbs from the factory have a mixture screw setting of between 1 1/4 and 1 1/2 turn out from being bottomed out. Then I would check the sync on the carbs next. If that doesn't cure it then you can call a parts dept and ask them what the factory jets are and verify that you have those installed. Unless you have a pipe or full exhaust they should be factory. If you have aftermarket exhaust of slip on then you might have to dig a little deeper and see if it has factory parts or a jet kit.

I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_5bac37c3cb991fdb

Front cylinder carburetor:

·
112.5 Main Jet

·
17.5 Pilot Jet

·
(1) 0.020" thick shim washer under the needle

·
PMS setting apparently varies from bike to bike... but it should be 2.5 turns

Rear cylinder carburetor:

·
110 Main Jet

·
17.5 Pilot Jet

·
(1) 0.020" thick shim washer under the needle

·
PMS setting apparently varies from bike to bike... but it should be 2.5 turns

Factory settings on both the High and Low jets were 1 1/4 turns out.

main jet 145
jet needle 4h11-3
needle y-2
pilot 17.5
float hight 26.6mm
pilot air screw 2and a quarter turnsout
main air jet 1.0mm
pilot jet 1.6mm

The FULL RESET CODE is *2767*3855#. This resets your mobile immediatly and sets it back to factory settings. PIN 0000 PASSWORD 00000000.

your factory jets should be ok with stock carb and exhaust,unless it came from way down south or someone changed them.factory jets are main jet #380,pilot jet #30

your main jet and pilot jet. Chaz Moto Dc

92063B SKU: 92063-1324
JET-MAIN,#148

92064A SKU: 92064-1108
JET-PILOT,#40