If you replaced those main units then you shoulda had spark unless there is no power going to the units . Check to see if the actually get 12 volts ...or 6 pending on your bike .. use a multi meter and see what kinda current is going to them and refer to your repair manual for proper voltage n amps ..12 volt no more than 30 amps ...6 volt 10 amps should be enough to at least spark threw coils . CDI boxes and other control modules are usually 10 amp either way .
Good luck and hope this helps
Hi and welcome to FixYa,
Initially, suggested checks on the wires:
Postback results of above voltage tests.
Good luck and thank you for asking FixYa. Happy Holidays.
1,789 views
Usually answered in minutes!
×