I don't know the bike but I doubt it is much different in principle than many others. The first possibility to consider is whether any immobiliser is functioning properly and is being properly disarmed before attempting to start. The owner's handbook would be a good place to begin...
Once you know the immobiliser is disarmed and power is flowing to the parts it is supposed to flow to, using the circuit diagram, the various supplies and grounds can be checked and using an oscilloscope check the output from the various sensors as applicable (crankshaft, camshaft).
Even though the bike has never been outside it might not have been immune from the effects of damp and condensation that can defeat many moisture barriers. It isn't unusual for electronic unit and sensor terminals to become dull, oxide coated and a barrier to current flow...
SOURCE: My 2004 Honda Shadow will not start. I have
I would get a test light and check if i had power to my coil and to my cdi module .You more than likely lost powerto one of them .those cdi last for every. check your switch make sure you got power there to. Hope this help
SOURCE: my keeway wont start
Check the fuses. Is the kill switch on or shorting out? Disconnect it and then check for spark. Sidestand/centerstand should be up, Got a good battery?
I am unfamiliar with your Keeway and just trying to help. Don't give me a bad rating if I miss the mark on this one. Thanks.
SOURCE: bike only fires once
Okay, let's have a look at it. Say Ahaaa.
The probable cause of the problem is not the spark. Get a fresh set of Stock NGK spark plugs, ground the plus to the engine, and check each cylinder for spark as the starter button is pressed for 3 seconds or so. I will wager that the spark is present.
The likely problem is the fresh gas was put into a very rusty gas tank. Bits of rust now inhabit your carb and are having fun plugging up the carb. Look at the gas valve. With a little luck there is a small bowl behind the valve. Remove it and tell me what you see in the bowl.
SOURCE: bike wont start
I would check for compression on the cylinders. a engine has to have fuel,fire and compression or it wont run. Check the specs to get the operable compression levels.
SOURCE: Battery will not hold charge after being charged. bike sat for yr
ck the chargingrate at the posts. Should be between 13.6 to 14.2. This is assuming the battery was properly filled with acid and charge before placing into service. The lower the voltage, the higher the amps. 12.0 max charging, 14.2v no charging good luck
116 views
Usually answered in minutes!
×