My 2006 Harley road king shakes alot when standing

kinda sounds like the motor mount between the jugs is bad

How much, when and where etc. Check your motor mounts for tightness.

You didn't describe the "click"

A series of rapid clicks means a low battery, or a bad (usually ground) connection, like if you crunched/abraded a wire along the lower frame when you drive over a curb.

A single, loud click indicates its a bad starter relay, about a $12 part:

http://www.ebay.com/itm/Starter-Brake-Relay-Switch-Harley-ROAD-KING-1991-2011-repl-OEM-31504-91A-/390652043658?pt=Motorcycles_Parts_Accessories&fits=Year%3A2006%7CModel%3ARoad+King%7CMake%3AHarley-Davidson&hash=item5af4ad218a&vxp=mtr

2006 road king classic I am putting on rear and back tiers with my friends tier machine and I need tork spects for axels rotors and lower fork bolts and brake calabers. I know it is alot to ask but do you know if there is something to down load or if someone can write me how.

roadkink

unfortunately these things can be a result of several problems , some things to check
excessive engine vibration....rear fork pivot shaft nuts loose, front engine mount bolts loose, engine to transmission mounting bolts loose, cracked or broken frame
surging and backfiring....bad spark plugs or cables, battery going bad, cables to battery or coil damaged or loose,intermittent short circuit due to damaged wire insulation, water or dirt in the fuel system or filter, fuel vent system plugged or fouled fuel injectors.
If you haven't had it fully serviced in a while I would suggest you take it to a dealer for one as some of the above problems require specialized equipment

You will have to measure your tire width and the frame width for the rear tire as Harley went to a wider rear in 2007

might check alt.out put but check batt connections first get a book and follow the directions to ck AC output youll need to rev the motor some unless you have a three phase alt.which you might ,the book will tell you

Take the bolt out of the kickstand, attach the spring, then use the kick stand for leverage to stretch the spring, and re-install the bolt...

Harleys are known for their shaking but when they get really bad I usually start looking for broken motor mounts. I suspect you either have a lose one or broken. The rubber wears out and then they get obnoxious.