2009 Honda CRF. will not idle and runs very rough after turning of Choke. replaced gas, drained gas. blue out the lines and cleaned the gas tank filter. removed air cleaner @
SOURCE: Briggs & Stratton engine on Murray lawn mower
I always replace the air filter if its a paper element, and even if its a foam element I replace it rather than clean it. That said, engine stumbling is rarely and air flow problem - but it could be, so having a new filter assures no air restrictions.
I would drop the carbuerator bowl. On the bottom of the carb, near where the fuel line comes into the engine, should be a nut. Removing this nut allows the bowl to drop off the carb. Some engines the bowl screws off, you will have to look at the bowl. Often the bowl has sediment or sludge buildup inside. Cleaning the bottom of the bowl can prevent that sludge/sediment from plugging the intake tube. Even on newer mower models this is a common problem, the gas line tubing interior breaks down and the inside of the tubing can start degrading - ending up in the bowl as sludge.
After cleaning the bowl, I would add one ounce of fuel line cleaner to a full tank of fuel and run the entire tank of fuel. This will clean any deposits or "varnish" from the interior carb parts. Doing this and the first step will assure your carb is clean and functioning.
If that doesn't help, then I would look at the spacing between the magneto and coil assembly. If you want to do that I'd like you to write down all the model numbers and serial numbers on the engine nameplate, that way I can give you specific directions.
Hope this helps,
Gregg
SOURCE: 2003 honda crf 150 will
The carb jets need to be cleaned.
Please take time to rate this fixya
SOURCE: running rough, wont idle, bad gas smell
Possible injector failure. locate by disconnecting injectors one at a time. The one that makes no change is the questionable. Status of spark plugs need chkg also. pull the plugs an the one that looks washed is questionable good luck
SOURCE: Won't idle without choke
The pilot jet controls the air/gas fuel mix at idle . If the jet gets plugged up not enough gas gets to the emgine at idle. You will need to remove the carbs and float bowls and clean them, paying special attention to the pilot valve. Count the number of turns to remove the pilot screw and replace the same number of turns then turn counter clockwise 1/2 turn.
A “very helpful” rating for this answer? Thanks!
SOURCE: High Idle On Start-up.
Most fuel injected motorcycles do start up in a "fast idle" mode. Although I don't know much about fuel injection on Harleys (H-D will not tell you much about it unles you are one of their technicians), I don't think the system is equipped with an engine temp sensor. Since the crank case sensor get it's pulses from pockets cut into the outer edge of the left side flywheel half, the sensor will have oil on it.
954 views
Usually answered in minutes!
real time work with facebook Im making over $2000 a month operating low maintenance. I continued hearing distinctive people divulge to me how an lousy lot cash they can make on line so I selected to research it. All topics considered, it become all legitimate and has without a doubt changed my life. For more statistics visit below site
HERE?..............................www.payshd.com
×