2008 qlink 700 frontrunner side by side dosen't seem to be charging.what do I check

I take help from online w ebsites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U can also get free manuals

If your description is accurate,, sounds like the shift shaft seal..or the countershaft seal(behind the sprocket)..

Typically most gear drive motorcycles use the same type of system. There will be a small bolt either 8mm or 10mm or a Phillips head . That will be at the bottom of the gear case just below the rear axle. Remove the bolt and let it drain. There should be a smaller screw or bolt of some sort above the axle. That will be the " weep " hole. Once you finish emptying the gear box. You re install the drain plug and fill the gear box through the weep hole. You fill it til it starts to come out past the threads. That is the correct fluid amount. Re install the weep hole plug and you're good to go.

I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_5bac37c3cb991fdb

you can get a battery charger from most canadian tires or automotive parts retailers. a car battery charger is what you need. you can do a trickle charge for the best results on it. its 12v.

Good luck

The plastic side panels have bolts just below the QLINK printed on the side(s) of the seat; take the 2 bolts out and the seat will slide to the rear and off.
Replace the seat by sliding the 2 "L" shaped holders on the bottom, front of the seat into their sockets and replace the 2 bolts

There is a recall on this - I just took mine to the dealer and they took the gas tank off and had to replace a wire . Might want to check with your dealer..2009 legacy 250 owner..