On a Kymco 700 side by side when i turn the ignition on all there is is a clicking /ticking sound, no lights up yet i had battery on charge over night plus had been on trickle charge for a few days

SOURCE: 2006 kymco 250 quad... failed

try tapping on the starter it may be in a bind if it still does nothing then change the solenoid

SOURCE: 2002 Polaris Sportsmen 700 with no power at

Remove the battery and use a wire brush to clean up the battery poles, and all of the connections. Also, find the bolt that connects the ground wire, the negative wire to the frame of the ATV and remove it and clean it all up as well. You most likely have a poor contact at one of these locations.

SOURCE: battery keeps loosing charge- kymco cruiser 125, 2005

I had this exact same problem on a hipster 125, it was a faulty regulator module ( mounted under the seat) I also found a short circuit (somewhere) in the wiring loom between the regulator output and the chassis (probably what killed the regulator in the first place!) I cut and replaced the entire wire to save removing most of the loom and after testing reg to ensure it was dead i fitted a new one (about £60) bike charges and runs like a dream now even with fully lights approx 80% of the time. good luck

Marvin

• 85242 Answers
• Posted on Jun 06, 2010

SOURCE: while driving door ajar chime goes off, clicking sound form behin

this problem is caused by a tiny micro switch that is attached to the door latch inside the doors, the stick and give this false warning, have replaced dozens of them, it is called the "door ajar" switch oddly enough :)

SOURCE: My 2006 Jeep Liberty won't start or turn over all I keep hearing is this click sound when I turn the ignition , Plus I just replaced the battery........What shall I check next?

check your starter,better yet has your alarm system been activated and possibly shut down your car a passive alarm will do that