1991 kawasaki ZZR 600 Logo
Posted on Aug 01, 2009
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

No power at the high/ low beam switch, so no head rear markers

No power at the high/ low beam switch, so no head light and no pwr at the rear markers with key on and also with engine running.looking for a starting point to trace for power and would like access to a light wiring diagram. 2nd concern-junction block, a cycling noise is heared when trying to start the bike, before the starter solenoid engages, is this a sign that the junction block starting to fail. found over heated terminal, possibly at the rectifier. for this bike a '91 ninja zx600d, the connector is six terminal connector, wear the lock is i'll refer to as being the top, has possibly gray, blck with yellow trace and white wires and bottom has three yellow wires, the middle yellow connector over heated both at the connector and the rectifire, backed probed for power-present.

1 Answer

Anonymous

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Brigadier General:

An expert that has over 10,000 points.

  • Master 6,966 Answers
  • Posted on Aug 01, 2009
Anonymous
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Brigadier General:

An expert that has over 10,000 points.

Joined: Apr 06, 2007
Answers
6966
Questions
17
Helped
3089284
Points
19604

Hi and welcome to FixYa,

On your concerns:

  • no headlight - check for +12 on blue wire from fusebox (preferably use a testlight rather than a voltmeter) to headlight switch; do the same to the blue / yellow wire from headlight switch to dimmer switch; the headlight switch is also responsible for switching the rear lights;
  • regulator connector - it is normal for the 3 yellow wires & the white wire to heat up as they pass the charging current to the battery and supply to the bike when running; cause of burning would be loose connection; it may be corrected by cleaning and tightening joint by crimping the female and force fit the male; a bit of electrical grease would be good;
  • wiring diagram - this version might be of help;
  • service manual - try here.
Good luck and thank you for asking FixYa

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

On 2004 pontiac montana what does fuse 7 control

7-BATT MAIN 1
60A
Fuses: •
CIGAR/DLC/APO FRT
• CLUSTER BATT
• CTSY LAMP
• ON STAR
• PWR LOCK
• PWR MIRROR
• RAP RELAY
• RR PWR SCKT

look below for above listed componet's , pull those fuse's one at a time till arc stop's ,then you found your problem circuit . Do you know where the I/P fuse box is ?
Fuse Block- I/P
Right side of the I/P, in the right front door opening


Fuse Block-I/P Label
Fuse Block-I/P Application Table Fuse/Circuit Breaker
Rating
Description
BCM PRGRM
10A
Body Control Module (BCM)
ENHANCED EVAP/AWD
15A
Evaporative Emission (EVAP) Canister Vent Solenoid, Clutch Pump Check Valve
CIGAR/DLC/APO FRT
20A
Auxiliary Power Outlet-Front, Cigar Lighter, Data Link Connector (DLC)
CLUSTER/BATT
10A
Instrument Panel Cluster (IPC)
CRUISE
10A
Cruise Control Module (CCM), Cruise Control Release Switch, Cruise Control ON/OFF Switch
CTSY LAMP
10A
Body Control Module (BCM)
DRL
10A
Daytime Running Lamps (DRL) Control Module
HVAC/DIC/DRL/HEATED SEAT
10A
Air Temperature Actuator-Left, Air Temperature Actuator-Right, Daytime Running Lamps (DRL) Control Module, Driver Information Center (DIC), Mode Actuator, Rear Window Wiper/Washer and Multifunction Switch (Heated Seat Switch), Recirculation Actuator, Relay Block (Rear Window Defogger Relay)
ELC/TRAILER
25A
Auto Level Control (ALC) Air Compressor, Auto Level Control (ALC) Air Inflator Relay, Auto Level Control (ALC) Sensor
FRT HVAC HI BLWR
30A
Blower Motor Resistor Assembly
FRT WPR/WSHR
25A
Windshield Wiper Motor, Windshield Wiper/Washer Switch
HAZARD
15A
Turn Signal/Multifunction Switch
HEADLAMP
20A
Daytime Running Lamps (DRL) Control Module, Headlamp Dimmer Switch, Headlamp Switch
HTD MIRROR
10A
Outside Rearview Mirrors-Left, Right
HVAC/BLOWER
25A
HVAC Control Module
IGN1
10A
Body Control Module (BCM), Instrument Panel Cluster (IPC), Left Rear Side Door Actuator Control Module, Rear Object Sensor Control Module, Right Rear Side Door Actuator Control Module, Stop Lamp Switch
LH HEADLP HIGH
10A
Headlamp High Beam-Left
LH HEADLP LOW
10A
Headlamp Low Beam-Left
LH T/LP
10A
Tail Lamp-Left, Trailer Rear Wiring Harness
MALL/CLUSTER
10A
Body Control Module (BCM), Instrument Panel Cluster (IPC)
ON STAR
5A
Vehicle Interface Unit (VIU)
PASS KEY
10A
Theft Deterrent Control Module
PCM/ABS
10A
Electronic Brake Control Module (EBCM), Fuse Block-Underhood, Powertrain Control Module (PCM), Park/Neutral Position (PNP) Switch
PCM/CRANK
10A
Powertrain Control Module (PCM)
PCM/PASS KEY/CLUSTER
10A
Instrument Panel Cluster (IPC), Powertrain Control Module (PCM), Theft Deterrent Control Module, Instrument Panel Cluster (IPC), Powertrain Control Module (PCM)
PWR LOCK
20A
Body Control Module (BCM)
PWR MIRROR
10A
Outside Rearview Mirror Switch
PWR QTR VENT
10A
Auto Level Control (ALC) Air Compressor, Auto Level Control (ALC) Sensor, Rear Quarter Window Switch
PWR/HEATED SEAT PSD
30A
Driver Seat Assembly, Passenger Seat Assembly
PWR SLDG DR
30A
Left Rear Side Door Actuator Control Module, Right Rear Side Door Actuator Control Module
PWR WDO
30A
Window Switch-Driver, Window Switch-Front Passenger
RAP RELAY
10A
Relay Block (RAP Relay)
RH HEADLP HIGH
10A
Headlamp High Beam-Right
RH HEADLP LOW
10A
Headlamp Low Beam-Right
RR HVAC/TEMP CONT
25A
Air Temperature Actuator-Auxiliary, Blower Motor-Auxiliary, Blower Motor Relay-Auxiliary, HVAC Control Assembly-Auxiliary, Mode Actuator-Auxiliary
RR DEFOG/ HTD MIRROR
30A
Window Defogger Relay-Rear
RR FOG LP
10A
Fog Lamp Relay-Rear
RR PWR SCKT
20A
Auxiliary Power Outlet-Rear
RH T/LP
10A
Tail Lamp-Right, Trailer Rear Wiring Harness
RR WPR/WSHR
20A
Window Wiper Motor-Rear, Rear Window Wiper/Washer and Multifunction Switch
SIR
15A
Inflatable Restraint Sensing and Diagnostic Module (SDM)
STOP LAMP
15A
Stop Lamp Switch
SWC BACKLIGHT
2A
Steering Wheel Controls-Left, Right
T/SIG
10A
Turn Signal Switch and Backup Lamp Relay
0helpful
1answer

I lost the fuse diagram for my dads 95 dodge grand caravan. Can anyone help me out with one?

#1: Panel Illumination
#2: Guages,Right High beam headlight and the high beam indicator
#3: Rear Wiper, Left headlight High Beam
#4: RH park, backup lights switch and relay,Speed porpotional steering module,power door lock switch illumination and daytime running lights(Canada)
#5: Power Door locks,Power Mirrors,vanity,dome,map,ignition and trunk lights,sunroof,radio,power antenna,body control module and power for the data link connector
#6:Heated mirrors,heated rear window indicator
#7: Instrument cluster illumination,park and tail lights
#8: Cigarette lighter,Radio Amp and horns
#9: Power door lock motors
#10: Not used
#11: Radio
#12:Left low beam head light
#13,14,15,16 not used
26153814-2qh1jtrzfrcszgktlooiom5o-3-0.jpg
0helpful
2answers

Low beam lamp(s) fault detected 2014 kenworth no low beam lights

First check light relay fuse, if ok check battery voltage at low beam light terminal, if ok replace low beam bulb, if no voltage check switch side of relay, if voltage replace relay, if no voltage check headlight low beam switch.
0helpful
1answer

My daughters 1998 vw cabrio has a top that won't go up or down. i need to find the fuse for it. i know it's not the motor or hydrylics i have already checked those out. so that leaves the button or the...

"my daughters 1998 vw cabrio has a top that won\'t go up or down. i need to find the fuse for it. i know it\'s not the motor or hydrylics i have already checked those out. so that leaves the button or the fuse... but i don\'t have a diagram for the fuse box. Please help. "

Here's the list and link for the fuse locations.

Fuse/Relay Locations on 1996 VW Cabrio.

Fuses, left to right:
1. Head light, low beam, left
2. Head light, low beam, right
3. Instrument & License plate lights
4. Glove box light
5. Wiper/washer
6. Fresh air fan
7. Tail light & side marker, right
8. Tail light & side marker, left
9. Rear window defogger
10. Fog lights
11. High beam & indicator, left
12. High beam, right
13. Horn
14. Backup lights
15. Open
16. Dash warning lights
17. Emergency flasher & turn signals
18. Fuel pump
19. Radiator fan & AC
20. Brake lights & cruise control
21. Interior lights & digital clock
22. Radio & cigarette lighter

Relays

1. AC
2. Rear window wiper
3. Digilant control unit
4. Load Reduction
5. Open
6. Emergency flasher
7. Fog lights
8. Intermittent wiper
9. Seat belt warning
10. Open
11. Horn
12. Fuel pump
13. Radiator cooling fan
14. Starting interlock
15. Open
16. Open
17. Open
18. Daytime running lights
19. Auto trans
20. Open
21. AC & power seats
22. Power windows
Google Image Result for http://www.2carpros.com/forum/automotive_pictures/266999_cab_1.jpg

1helpful
1answer

'99 ford escort head light will dim when

The wiring harnesses in the plugs behind the bulbs are burned up seperate rear of headlight cover and inspect parts available at your ford dealer
0helpful
1answer
0helpful
1answer

I have a 1990 audi quattro V8, both low lights went out.. Marker lights and high beams both work

I would check the low beam fuses. Also maybe a bad dimmer switch. Check to see if you have power at the low beam headlight plug.
3helpful
2answers

Need a diagram of the fuse box for a 1994 volk

Heres a picture of fusebox,and listed is the fuse locations,1) 10amp left low beam light
2)10amp rt low beam light
3)10 amp instrument& license plate light
4)15 amp, rear wiper
5)15amp frt washers and wipers
6)20amp A/C fresh air fan.
7)10amp rt tail & side marker lights
8)10amp left tail & side marker lights
9)20amp rear defroster &heated mirrors
10)15amp fog lamps.
11)10amp left high beam
12)10amp rt high beam
13)10amp horn, rad fan run on
14)15amp backup lights (m/t),power mirrors,heated seats,heated washer jets,cruise control (m/t)
15)10amp engine electronics,coolant pump run on(v6)
16)hazard signals,glove box lite,shift lite
17)10amp turn signals
18)20amp fuel pump, oxygen sensor
19)30amp a/c, rad cooling fan.
20)10amp brake lights,cruise control.
21)15amp dome light,cigar lighter,locking system,multifuntion indicator,clock,vanity mirror.a94b062.gif
0helpful
1answer

No low beams have high beams and marker lights both are out

you just need new head lights, the high will still work if the low is out
0helpful
1answer

1999 Chevrolet Astro Van problem

the head lights have tree wires goig to it one groun one gets power when high beams on the 3rd gets power only with low beam on test the wires or try by plugin a good known head light to conector if it works with low beam then replace both head ligts because head light come with two bulbs in one high and low
Not finding what you are looking for?

350 views

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Bob G

Level 2 Expert

104 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...