Hy, Please tell me what is it when the red bulb with engine motor sign can't turn off

I would try asking a Bosch seller. Partco, Napa etc.

White is the MIC wire
Copper shield is GROUND
Black is usually PTT, otherwise use RED for PTT




The above drawing is the TS-440SAT mic connector pinout. The pin numbers should be visible on the MIC connector.

You can get the complete manual at www.mods.dk for free.

White is usually the audio wire. Black is ground and red PTT. The shield goes to the mic ground connection. The pinout is in your TS-440 manual.

You need to take it to a shop and have it scanned so you know the t-case fault codes (transfer case)

If the red light dims severely or goes out when you try to start it you have a flat battery, highly likely if that red symbol has been on while the motor has been running because the alternator hasn't been charging. It could mean you have a broken drive belt but that would also mean no power steering, AC or coolant pump drive so that would have been obvious fairly quickly.

P1159 - variable induction motor rotation.. plastic gears stripped on the variable intake shaft-motor gearset.. PCM drives motor, sensor is watching shaft movement, but no movement seen.... $500 for intake plenum alone..
(IMG:http://www.hmaservice.com/data/Passenger/HY/HMA/ENG/DTC-images/HY-XG13-IMAGES-ENG/xg35dp201511.gif)

p1191 fuel rail pressure sensor circuit low.

P1195- tps sensor low voltage.

Take it to autozone or another auto parts store to run a diagnostic for free and see what they say

WELL REAR TAIL LIGHT SIGNAL BULB SHOULD BE CLEAR BULB FRONT TURN SIGNAL BULB SHOULD BE ORANGE COLOR.TAKE BULB TO ANY AUTO PARTS STORES THEY WILL GIVE YOU THE CORRECT BULB.

key might need to be coded ask in volkswagon garage

faulty stepper motor.

Find out how to open it up, then take out bulb and buy replacement at Auto Good stores like Kragen which might tell you how to do it.