After turning on the key the gage start working like normal and all the lights go out except now the oil light stays lit and when trying to start the engine, nothing happens. Kickstand is up, handlebar switch is on start, brake handles are pulled, and starter button is pushed with no response.
SOURCE: My kymco zing only kick starts.
Hi, I'd check that one of the brakelight switches isn't stuck on, as if it's the park light it should put the front one on as well, some bikes have the headlight/taillight hardwired so come on with ign. on. The starter should have a fuse, check it, if ok, follow the main wires from the starter motor to the solinoid & check power's getting through with a test light (an old globe with a length of wire will do), the solinoid should have one large power cable to it from batt. with full time power, another the same going to starter that get's power when start button's pressed & a smaller one which should get power when start button's pressed (activates solinoid). if it is getting power to the starter when button's pressed, starter probably needs new brushes or just a good clean out, hope this helps.
SOURCE: Electrical Problem, lights etc not working, engine ticks over tho
Check the battery negative cable if its tightened well to the frame or the engine, check too, the fuse box and the main wire to the starter solenoid and the connections to the starter too, this sounds to be an electrical lose connection somewhere..just go along throught the wires and connections..
Hope this helps!
SOURCE: I have a Kymco People
have you checked the spark plug? take it out and lay it on the engine touching a metal part and kick the bike you should see it sparking if not then replace the spark plug
if thats not the problem then give the carb a clean and check the air filter that its not blocked
2 stroke bikes need three things to work air spark and fuel as long as you have these it will work
hope this helps
John
Check with a multi tester for voltage coming through the ignition switch lead wires + to switch wire - to ground you shoul get 12volt or higher, with the switch off you should have one live (feed from battery ), on you should have 2 or 3 in and out feed (possibly 2 out one for ignition one for light curuit), or disconnect the switch and check for continuity (12v battery wire and a bulb if you dont have a multi tester between each pin on the switch plug when turned on you should get a curcuit when on.
575 views
Usually answered in minutes!
×