SOURCE: On a 1986 kawasaki ninja
This may differ from model to model, as a rough guide with standard jetting, 2.5 to 3 turns out, screw the air corrector screw home (in) all the way until it stops using no force, as soon as you feel it is home stop, then unscrew the screw 5 half turns which equates to 2.5 full turns as a base setting, any furter addjustments should be done in half turn increments in or out untill the bike runs at its best
SOURCE: How do I disassemble a carburetor on a 1996
Hello, the leak may be caused by the carb gaskets or seals drying out and splitting if the bike has been sat idle for a while.It may well be that the float for that carb is punctured and sits at the bottom of the float chamber. This will cause the needle valve to stay open and will allow the carb to flood all the time and fuel will leak.
Best advice I can give is be careful, get a manual, draw pictures or take photographs. Work in a well ventilated space with a markd out area for dismantling the carb.Do one carb at a time and do not mix any parts. As you dismantle parts use indelible marker or a small screwdriver to scratch location lines for re-assembly. Never trust your memory if it is going to take more than one hour to complete.
Make sure that you have the spares to complete the task befor taking anything apart.
Use masking tape to hold small parts in the sequence that they are dismantled.
Do not let your mates or children touch anything
Make sure the battery is disconnected before you start any work on the fuel system
Good luck jamesey555
SOURCE: how do you get the gas tank open 2002 Kawasaki zx ninja 600r
Should be the same as any other bike. Put the key in the gas tank and turn. Might require some fiddling, but is there not key hole in the filler cap or something?
555 views
Usually answered in minutes!
×