SOURCE: i recently bought a suzuki rm 125 and it wont run
the idle buddy is too low,on the carb is a screw the ide screw turn it in 1/4 of a turn with the bike running untill it idles the way you want it too and it will idle the pic below ill help ya buddy
SOURCE: Float level measurements
there should be a line on the float bowl, if not set the carbs upside down on a work bench get eye level set floats to where you can only see half start there ,if they over flow back off a bit GET A MEASUREMENT IF POSSIBLE oh you'll have to make a aux fuel cell if you dont want to pull on and off seems like some specs are tuff to find so do this hope this helps
SOURCE: suzuki gp 125 1981 dont want to start
hi i have a suzuki gp 125 1984 its starts up but only on full choke and if you take the choke off, it bogs out, then cuts out. what could this be ?
SOURCE: I have a 1971 suzuki ts 125 and I can't seem to
Hi, the standar for the air/gas screw is 1 & 1/2 turn out from total screw in. Start from there and then you only need minor adjustments. As for the 5 min ride and then nothing, check you fuel suply, start with the buoy level inside the carb.
good luck
226 views
Usually answered in minutes!
×