Lost keys can I remove the ignition - Motorcycles

I replaced the ignition on my truck. There should be a plastic shroud on the bottom of the steering column. Locate the screws and remove it. Then see if there is a small hole that a small diameter screwdriver can fit into. This should allow the ignition switch to be removed.

the key fob? or radio remove or what?
remote to what.

the operators manual covers this , under car keys.
the car came with 2 Fobs. lost them both now>?
RKE its called, (makes looking fact more easy)
is this car with SKIS Immoblizer option> yes./no
if yes.
SENTRY KEY IMMOBILIZER SYSTEM - IF
EQUIPPED
im reading your operators guide now.
lost that too>?
Duplication of keys may
be performed at an authorized dealer (or locksmiths) or by using the
Customer Key Programming procedure.

DIY, takes 1 key , good, called a valid key, in the below text.
You can program new keys to the system if you have two
valid keys by doing the following:
1. Cut the additional Sentry Key Transponder blank(s) to
match the ignition switch lock cylinder key code.
2. Insert the first valid key into the ignition switch and
turn the ignition switch ON for at least 3 seconds but no
longer than 15 seconds. Turn the ignition switch OFF and
remove the first key.
3. Insert the second valid key and turn the ignition
switch ON within 15 seconds. After ten seconds, a chime
will sound and the SKIS indicator light will begin to
flash. Turn the ignition switch OFF and remove the
second key.
4. Insert a blank Sentry Key into the ignition switch and
turn the ignition switch ON within 60 seconds. After 10
seconds, a single chime will sound. The SKIS indicator
light will stop flashing, turn on for 3 seconds; then turn
off.
The new Sentry Key has been programmed. Repeat this
process to program up to a total of 8 keys.


did i guess right, the Key FOB RKE,
remove key entry fob.?

to reprogram new key first you need to use 2 factory program keys.place first factory key in the ignition first turn ignition on for 3 seconds. then turn off ignition then install second factory in the ignition on position for 10 seconds.when immobilizer warning lamp begins to flash a acoustic signal is emitted.within 60 seconds. switch ignition off and remove key.then insert new key and switch on for 10 seconds a acoustic signal is emitted and immobilizer warning lamp remain illuminated for 3 seconds indicating programming completed.if all fails dealership has to reprogram new keys.

A key code is stamped on the lock cylinder to aid in replacing lost keys.

How to remone 1998 windstar GL (3.8 L) Ignition Locl.

Go to any GM dealer ship with proof of ownership and the registration/title of this truck and keys can be made

http://www.carlsalter.com/motorcycle-manuals.asp

get a free pdf service manual for your bike here. you should find out how to remove the ignition. or if you have a seat lock that is easier to remove take that to a locksmiths to get new key cut

If you just need an ignition key, take your title and ID to a Chevy dealer. They may be able to provide you with new keys.

Why are you taking out the old one. Check with any good locksmith. If your door key fits the ignition, you can easily remove a door lock cylinder and the locksmith can make you a new key!!! I'm pretty sure to remove your lock you need to turn it with the key in it (but you don't have one)