Where can i get the ignition coils for a qianjiang motorcycle

there is a few things you can check

1. check the connection between the coil and the plug
2. make sure all the wires are connected to the proper spots
3. replace coil if needed

Sounds simple, but do you have a kill switch on your scooter? Be sure it is not in the kill position.

Spark wire or ignition coil

It has no points, it has a electronic ignition system
CDI (capacity discharge ignition) no points.
only motorcycles i remember with points i remember where in the early 1970s by mid 1970s everything is electronic.

with a two wire coil, one is a ground, the other is from the capacitor in the CDI. Forgoing any re-wiring from an amateur, it may be your CDI is shorted. It's hard to tell from here.

It may seem like a fuel problem, but is likely low compression. Changing the air filter will do nothing. Check your compression with a tester to be sure. If it is 120-220 psi, then I would look at the ignition system, starting with the plug, then wires, CDI, coil, charging coil, etc.

www.ec21.com/manufacturers/qianjiang.html

or

www.motorcycle-bike-parts.com/.../motorcycle_parts.html?...Qianjiang%20YAMATI... -

Honestly, your best bet would be a Qianjiang motorcycle dealer in China. I don't know of any dealer in USA.

the magneto connects straight to the coil

You can buy sperate parts at dansmotorsports or go to a local motorcycle dealer