Motorcycles Logo

Related Topics:

d
david hansen Posted on Dec 17, 2015

How do i find the key codes for a 1982 honda silverwing gl 500

1 Answer

Neil Lancaster

Level 1:

An expert who has achieved level 1.

Corporal:

An expert that hasĀ over 10 points.

Welcome Back:

Visited the website for 2 consecutive days.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 14 Answers
  • Posted on Dec 17, 2015
Neil Lancaster
Contributor
Level 1:

An expert who has achieved level 1.

Corporal:

An expert that hasĀ over 10 points.

Welcome Back:

Visited the website for 2 consecutive days.

Problem Solver:

An expert who has answered 5 questions.

Joined: Mar 27, 2008
Answers
14
Questions
1
Helped
2972
Points
22

I have one here and the number is on the blade of the key

5 Related Answers

Anonymous

  • 2 Answers
  • Posted on Apr 21, 2009

SOURCE: Owners Manual for 1982 Honda 1100 Goldwing Interstate

Here is link where you can download service manuals and owners manuals for free.

http://www.goldwingdocs.com/

Ad

Anonymous

  • 17 Answers
  • Posted on Jun 15, 2009

SOURCE: i have two loose hoses coming off my petcock? where do they go

On your silverwing you have a "vacuum operated petcock" which means that the carbs draw a vacuum and allow the fuel to flow from the petcock. The front hose is the vacuum hose that should run to the center of the carbs. The second is a drain hose - it's advised that you do have a small hose connect here, so that dirt does not find its way into the petcock. This hose will simply run down past the swing arm to the ground. This would prevent any gas from dumping itself onto the engine if your petcock fails. If your bike runs without the vacuum hose attached, your petcock has failed and will need to be rebuilt.

Anonymous

  • 311 Answers
  • Posted on Jul 04, 2009

SOURCE: can I use gl-5 80 90 wall-mart brand gear lube in

if the bike is a shaft drive,then the oil you are referring to is a gear oil only,will be fine in the rear drive unit as most standard hondas use 80-90 as standard....but under no circumstances put this grade of oil into your engine or gearbox,you will destroy the motor in a very short time

Anonymous

  • 17 Answers
  • Posted on Dec 01, 2009

SOURCE: Need a downloadable version of repair manual

You can check out www.trainwiththom.com - he's got all of the stuff that you'll need

Here's the link straight to his 'manual' page

Anonymous

  • 1 Answer
  • Posted on Jul 02, 2010

SOURCE: honda silverwing scooter where is the v matic

how to reset v light on honda silverwing scooter?

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How do I change the air filter in my 1982 Honda Silverwing GL_500? The filter didn't have instructions.

Take off your right side cover (part #9) http://www.bikebandit.com/houseofmotorcycles/1982-honda-gl500-silver-wing-500/o/m9607#sch409523 and you will see the air intake horn on the side of the air box. Turn the cover counter clockwise and pull the air filter straight out the side of the air box. The cover you turn is part # 2 on the diagram. http://www.bikebandit.com/houseofmotorcycles/1982-honda-gl500-silver-wing-500/o/m9607#sch409523
0helpful
1answer
0helpful
1answer

I purchased a 1981 Honda Silverwing 500 gl. There is coolant leaking periodically from the small right side bolt on the very bottom engine cover. The dealer replaced the mechanical seal on the end of the...

hi
sounds like you have a small fracture in the casing (cover)
i would start at the basics and replace the casing (cover)
but whatever you do do not overheat that engine
with that engine the barrels are part of the engine
and cannot be replaced
and if you overheat that engine
the engine warps rather than warps the alloy heads

failing that failing the replacement of the casing
the bolt hole that the bolt goes into
at one time may have had a longer bolt in there
and has gone through the bottom of the hole
there is a product called chemical metal
take the casing off clean all surfaces
mix up the chemical metal and fill the bolt hole up
you will now need to re-drill the hole and tap a thread into it
rub down any excess chemical metal
and make the surface flat again
new seal (gasket)
use some harmalar (instant seal) if need be
Sep 02, 2017 • Motorcycles
1helpful
2answers

1982 500cc honda silverwing, bike is charging @ aprox. 11.5v , also when right signal is put on right side running lights go out, are the 2 conected(ground short) ? or maybe stater? , new to bikes with no...

1st, Your alternator is charging real heavy. the lower yhe voltage the hidher the amps. 2nd, yes, Turn on one and the other dima is indicarive of a poor ground which would in turn affect the charging rate. Nowm The bad ground is more than likely the battery cable on the negative. But, Check the other end of the cable also. good luck- Ned
Not finding what you are looking for?

109 views

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...