SOURCE: really bad rattle/shaking after hitting 3000rpm
check motor mounts....sounds like they are loose...
SOURCE: My honda cbr 125 feels is hard to steer as slow speeds.
Sounds like the cap nut in the center top of the steering stem may have been tightened up a little too much. Get the front end into the air and turn left and right. Stiff? Loosen the cap nut until the handlebars move freely. Now it could also be that the steering stem bearings need a bit of grease. Some dis-assembly is needed for that fix. The only other thing that would make the steering stiff is low tire pressure.
SOURCE: No power on my Kymco Zing 125
your best try is to contact your dealer, and get them to order you the short red wire that runs from the + terminal on the battery, to the starter soleniod ( also has a thin red wire that runs to fuse holder) i had exactly the same problem and this solved it. i have however re done all the electrical connections on my bike using 7amp wire and bullet connectors, as i have had many faults with the electrics before.
My bike is a Kymco Cruiser 125 (almost exactly the same bike, i use kymco zing parts when replacing) i paid approx £16 GBP for the wire.
SOURCE: My Kymco Miler 125 scooter indicators dont work.
harness issue?i was an electrical sysems troubleshooter on planes.do any other switches do anything crazy?
SOURCE: what oil do i use
Synthetic oil 15w 40 recommended by the manual or 10w 50 depending on the temperature in your area. greetings from the club Stryker Argentina.
http://kymcostryker.fullblog.com.ar/
157 views
Usually answered in minutes!
×