Lost key for 1999 Chrysler Cirris.need to replace ignition lock cylinder

SOURCE: ignition lock cylinder

take the registration or title to your local dealer and have a key made from the VIN

SOURCE: replace ignition lock cylinder 1996 BMW 318i with 1995 BMW

no you can not

SOURCE: need to remove the ignition lock cylinder to replace it cause the key is lost

turn the ignition to the on position then on the bottom of the steering colum just under the lock cylender thare is a hole that leads up to the cylender. get a straight pick or somthing with a point on it and insert in hole apply a little steady force while pulling straight out on the cylender. i am assuming you are talking about the ignition lock cylender.

Jim Goldsmith

• 2005 Answers
• Posted on May 19, 2009

SOURCE: Removal of 1998 toyota cressida ignition key cylinder.

This car has drillable shear pin screws on the bottom of the lock yoke you must drill these out.
then release the clip to the cylinder. you must get a new set of break-off shear pin head screws from the dealer to finish the job.

Greg Bernett

• 2993 Answers
• Posted on Jul 26, 2009

SOURCE: i need to take out old ignition lock cylinder

This is what the tech manual says.....

Ignition Lock/Switch REMOVAL & INSTALLATION

1. Disconnect the negative battery cable. If equipped with an air bag, wait at least 90 seconds before working on the vehicle. CAUTION
   Some models covered by this manual may be equipped with a Supplemental Restraint System (SRS), which uses an air bag. Whenever working near any of the SRS components, such as the impact sensors, the air bag module, steering column and instrument panel, disable the SRS, as described in Section 6.
   
2. Remove the lower steering column cover. Unfasten the ignition switch connector under the instrument panel.
3. Remove the screws which secure the upper and lower halves of the steering column cover.
4. Turn the lock cylinder to the ACC position with the ignition key.
5. Push the lock cylinder stop in with a small, round object (cotter pin, punch, etc.). NOTE: On some vehicles, it may be necessary to remove the steering wheel and combination switch first.
   
6. Withdraw the lock cylinder from the lock housing while depressing the stop tab.
7. To remove the ignition switch, unfasten its securing screws and withdraw the switch from the lock housing. To install:
   
8. Align the locking cam with the hole in the ignition switch and insert the switch into the lock housing.
9. Secure the switch with its screw(s).
10. Make sure both the lock cylinder and column lock are in the ACC position. Slide the cylinder into the lock housing until the stop tab engages the hole in the lock.
11. Install the steering column covers and connect the ignition switch wiring.
12. Connect the negative battery cable.