At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Torque settings volvo V40 TD 1,9 ? Cylinderhead? I renewed the head gasket but can't find the torque sttings of the cylinderhead.. in Kg please... Thanks!!!!!!!!!!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Toyota Yaris Main and Big end Torque settings:
Tighten the main and big end bolts in sequential order and in two steps.
Main bearings. Stage 1.
22 ft lbs.
Stage 2.
44 ft lbs
Big end bearings.
Stage 1.
11 ft lbs.
Then Rotate bolt head a further by 90 degrees
Head bolt torque must be done in 3 steps:
1st 22 ft lbs
2nd 43 ft lbs
final 47 ft lbs
use this sequence of tightening:
9 - 3 -1 -6 -8
7 - 5 - 2 -4 - 10
tighten main large cyl head bolts like this. stage 1. 29nm
stage 2 .59nm stage 3.slacken off. stage 4. 29nm. then stage 5 50 t0 55 degrees start in the centre of the head and work outwarward diagonaly then tighten the small bolts @the front of the head 6.8 to 8nm
Install the gasket so that the surface with the identification mark faces toward the cylinder head.
Tighten the bolts to the specified torque in the sequence shown below.
What engine?
B21 Motors with insexbolts:Tighten in 3 steps: 40 - 70 - 110 Nm. After varming up and cooling down, loosen slightly and tighten again to 110 Nm. Wngines with stretchbolts: (hexhead 14 mm) Tighten in 3 steps: 20 Nm, 60 Nm and 90 dgrees = 1/4 turn. No after torqing. B230Cylinderhead 3 step: 20Nm, 60Nm, 90 degrees. B234: 20Nm, 40Nm, 115 degrees
According to my haynes manual for Landrover 200tdi, G - S reg,1989-1998 it goes as follows,
Stage 1:- Tighten all bolts to 30lb ft or 40Nm then
Stage 2:- Angle tighten a further 60 degrees then
Stage 3:- Angle tighten a further 60 degrees again.
×