NNeed torque specs for 2010 harley ultara classic, front axle nut, front brake calipers, axle nut holder

Front caliper -

Brake Pad Pin = 75-102 INCH lbs.

Caliper to Fork Bolts = 28-38 FOOT lbs.

Tighten the rear axle nut to 60-65 ft.-lb. (81-88 N•m).
Front axle nut
FXST, FLSTC, FLSTF,
FXSTB and FXSTD 50-55ft/lbs - 68-75 NM
FLSTS and FXSTS 60-65ft/lbs- 81-88 NM
Brake disc bolts
Front wheel 16-24 ft/lbs- 22-32nm
Rear wheel 30-45 ft/lbs- 41-61nm

Support the motorcycle with the front wheel off the ground.
Remove the caliper mounting bolts and remove the caliper
Place a plastic or wooden spacer between the brake pads in place of the disc. Then, if the brake lever is inadvertently applied, the pistons will not be forced out of the caliper.If the pistons are forced out, disassemble the caliper to reseat the pistons.
Insert a drift or screwdriver through the front axle hole on the right side to prevent it from rotating.
Loosen and remove only the left side axle nut.
On the right side, loosen the fork slider axle clamp nuts
Prior to removing the front axle, note the location of
the right side spacer and left side spacer. The spacers must
be reinstalled on the correct sides during installation.
Withdraw the front axle from the fork sliders and front wheel.

Front axle nut torque 70-75ft lbs, rear axle cone nut first torque 15-20ft lbs, second torque 95-105 ft lbs, front disc torque 16-24 ft lbs, rear disc torque 30-45ft lbs.

caliper torque 28-38 ft lbs,front axle nut torque60-65 ft lbs. front brake rotor torque 16-24 ft lbs. straight from harley manuel.

Front axle nut = 50-50 ft. lbs.
Front axle pinch bolt and nut = 21-27 ft. lbs.
Front brake caliper mounting bolts = 25-30 ft. lbs.
Handlebar clamp bolts = 12-15 ft. lbs.
Front Fork
Upper bracket pinch bolts = 30-35 ft. lbs.
Lower bracket pinch bolts = 30-35 ft. lbs.
Fork stem pinch bolt = 30-35 ft. lbs.
Front fender fasteners = 9-13 ft. lbs.

THE LUG NUT TORQUE SPEC - 140FT/LBS\
CALIPER MOUNT - 80FT/LBS
CALIPER BRACKET 129FT/LBS
AXLE NUT 177FT/LBS