2000 Harley Davidson FXSTD Softail Duece Logo
D
Don Daus Posted on Jul 27, 2014
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Harley turn signal problems

NO blinkers, checked turn signal module for 12 dc at pins 1 to 2, have 12volts. How do I check module before buying one, cost $149.00

1 Answer

Harry Goodwin

Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

  • Expert 353 Answers
  • Posted on Jul 31, 2014
Harry Goodwin
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

Joined: May 07, 2009
Answers
353
Questions
0
Helped
135678
Points
766

The turn signal module (TSM) is an electronic microprocessor that controls the turn signals and four-way hazard flasher. The turn signal module receives its information from the speedometer and turn signal
switches.
On models equipped with a security system
(TSSM), it is incorporated into the TSM module. The
bank angle sensor (BAS) provides motorcycle movement
signals to the module. TSM and TSSM modules are not
interchangeable.
The turn signal module, TSM or TSSM, is located on
the electrical panel located in front of the rear wheel.
When there is a problem with either system, a diagnostic fault code(s) is set. The TSM or TSSM can only be tested with Harley-Davidson diagnostic equipment. If any portion of the module is inoperative, refer the testing to a Harley-Davidson dealership

5 Related Answers

Anonymous

  • 4 Answers
  • Posted on Aug 18, 2010

SOURCE: 2001 harley 883 right turn signal wont flash. Not

check your front and rear signal 'sockets" where the bulb goes in, check for rust or a bad connection shorting it out. If that's not the problem, chech the wires under the rear fender to see if you have a bare wire from rubbing on the tire when hitting potholes etc. I had the same problem on my 92 softail. hope this helps.

Ad
OneRide

Gar

  • 384 Answers
  • Posted on May 02, 2009

SOURCE: left turn signal an speedometer

There was a recall on the speedometers about 2004.
Some were defective and just quit working. H-D replaced them for free. Not sure about your year/model, but I would contact a dealer or area service rep to see if it falls under the guidelines.

cdnrdnk

  • 8 Answers
  • Posted on Sep 20, 2009

SOURCE: 2007 harley softail turn signals left side stoped

More than likely a broken wire you will have to trace

Anonymous

  • 4088 Answers
  • Posted on May 24, 2010

SOURCE: Brake lights,turn signal and horn not working...

Check the wiring within the headlight shell--look for connectors that may be corroded or pulled loose. A little WD-40 will favor connection integrity when sprayed into the connectors, then coupling and uncoupling them several times. Hope this helps!

ultrat

Mot Smith

  • 500 Answers
  • Posted on May 04, 2011

SOURCE: how to install badlands turn signal cancelling

I do not know sorry ..But I have gotten great help at harleytalking.con '';';'

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

No Turn Signal front Back. no running lights back. Every thing else fine Horn brake tail lights

See if bulb sockets are corroded, check blinker unit & check all electrical connections & grounds.
0helpful
1answer

The turn signals on my 2000 harley heritage will not flash off and on.At first the turn signals would flash but would not cancel by them self and now they will not do anything

Your turn signal module has failed or has a weak electrical connection. Disconnect, clean, and reconnect the 12 pin connector. If this doesn't correct the problem, replace the turn signal module.
3helpful
1answer

No turn signal or 4 way flashers on 2000 flhtcui , all other lights working

The turn signal module gets it's power from the accessory fuse. If the fuse is good, check for 12 volts at the #2 position on the turn signal module (located on the top fork bracket). On the turn signal module the #1 wiring pin position is ground and the #2 wiring pin position is 12 volts dc. If there is no voltage using those two pins, check for resistance between pin #1 and engine ground. If resistance is greater than 1 ohm you have a broken or poor ground wire. If resistance is less than 1 ohm check for 12 vdc on both sides of the accessory fuse. If you have 12 vdc to only one side, replace the fuse. If you have 12 vdc to both sides of the fuse you have a broken wire between the accessory fuse and the turn signal module. If you do not have 12 vdc to the accessory fuse you have a broken wire from the ignition switch and the fuse block.
0helpful
2answers

Turn signals wont turn off

This could be a loose connection, or the signal timer relay has gone out.
Not finding what you are looking for?

6,665 views

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...