Disk Brakes - remove two 14mm bolts which mount the caliper to the rear hub assy. Remove the caliper. Remove the phillips screw which holds the rotor to the hub. Machine the rotor and reinstall on the hub & reinstall the phillips screw. Reinstall the caliper and remove one of the caliper hinge pin (sliding pin) 14mm bolts. Flip the caliper out of the way and replace the pads and anti-rattle springs. Recompress the caliper piston all the way back into its cylinder. Flip the caliper back into position and reinstall the 14mm bolts. Of course, you need to purchase the replacement pads and w/anti-rattle springs.
SOURCE: change brake light switch
The switch is located under the drivers side dash behind the brake peddle arm.
1,192 views
Usually answered in minutes!
×