2006 Yamaha V Star 1100 Custom Logo

Related Topics:

A
Anonymous Posted on Jun 30, 2014

1998 yamaha v star classic will only run on the choke

Good fuel supply to the carburetors but it dies when you give it throttle.The engine will only run on full choke .

5 Related Answers

Anonymous

  • 12 Answers
  • Posted on May 18, 2009

SOURCE: Yamaha 06' V-star 650 idle prolbem!

Fuel filter is located near the fuel shutoff valve within three inches. It is inline between the shutoff valve and the fuel pump (towards tank).

The fuel circuit is: Tank/Fuel Pump/Fuel Filter/Fuel Shut-off Valve/Carbs.

You first step is to check for fuel delivery to the filter. Make sure the bike is cool and no iginition sources are nearby. Disconnect the inlet line at the filter and turn key on and crank engine (to trigger fuel pump.) Do not try and start at this time (choke off).

If fuel is adequate to the filter, check the filter by blowing through it, it should easily pass air. Replace filter if questionable.

Next reconnect the fuel lines and remove float bowl drain plugs in the back of the carbs (2 per carb). If with key on and cranking fuel pours out of these ports then you probably have clogged fuel jets. If not then the float bowl needles / pipes could be plugged with varnish from dried fuel. You can try spraying carb cleaner into the fuel inlet to clear the varnish and then retest. Careful not to spray carb cleaner on yourself (wrap straw with a rag).

If you have good fuel flow to the carbs and bowls you probably have varnish plugging the jets. You should remove the carbs and clean them thoroughly.

Hope this helps,

Kal

Ad

Anonymous

  • 15 Answers
  • Posted on May 26, 2009

SOURCE: Yamaha V-Star 1100 backfires and will not run without choke on

Here are two solutions for you:
A - Take the carberator off and soak it in some good quality carb cleaner for about 1/2 an hour.  That should take care of any residue in the carbs.
B - Alternatively (and for the less technical minded) there is a great product called Sea Foam.  Try to find it at your local CSK auto/NAPA/Wal-Mart.  Pour a small amount (maybe 1/4 ounce) into each cylinder chamber (take out the spark plugs), try to pour a small amount into the carbs (a turkey baster works great for this), and pour the rest into the gas tank.  Let it sit for 5-10 minutes, then start it up.  *NOTE - the bike will start VERY hard at first until it burns through what's in the cylinders.  ALSO the fumes will be EXTREMELY strong and suffocating - make sure you do this OUTDOORS preferably, or at least in a VERY well ventilated area.
Good luck - I know how frustrating these things can be! :)
P.S. - I am a proud owner of a V-Star 1300 - great bikes! :)

Anonymous

  • 48 Answers
  • Posted on May 26, 2009

SOURCE: Fouled Fuel System on 2005 Yamaha V-Star 1100 Classic

put a new filter on it

Anonymous

  • 1167 Answers
  • Posted on Oct 06, 2009

SOURCE: Carburetor issue

make sure the oil level is correct also on carb is a screw fiddle with this mixture screw and get back to me if it made no difference i will send a pic in a while

Anonymous

  • 8909 Answers
  • Posted on Feb 28, 2011

SOURCE: Lost of power on throttle increase and motor dies

I would say you have a blocked or damaged jet. I would strip down the carburettor and replace any badly worn jets and clean thoroughly. When refitting the tick over mixture screw , screw it home and back out about 2 1/2 turns. That will be somewhere near it.
Hope that helps.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

V star quits when throttle is applied carbs redone and cleaned. I give up!!!!!!

how about the plugs or fuel line itself could be a bad fuel pump wihich are in the tank ck the fuel pressure
0helpful
1answer

My 2002 1100 v star classic does not run on the front cylinder, has spark, has compression, front cylinder stays cold. Back cylinder runs on spark, fuel, compression, no problem. Give any throttle and bike...

How good did you clean the carbs? The idle jets usually have small holes along the side, and if they are blocked with dirt or bad fuel, it won't idle. Make sure ALL of the passages are clear, and all jets are clear, through the center and holes in the sides of the pilot jets.
0helpful
1answer

99 CBR will start but wont run

did you check the fuel filter and fuel supply?
Not finding what you are looking for?

171 views

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

vince

Level 3 Expert

2530 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

littlewheel

Level 2 Expert

122 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...