1980 Yamaha XS 650 G Logo

Related Topics:

A
Anonymous Posted on Jun 29, 2014

Where is oil filter on 1980 yamaha 850 - 1980 Yamaha XS 650 G

5 Related Answers

Anonymous

  • 267 Answers
  • Posted on May 12, 2010

SOURCE: check the oil

There is a small glass inspection window on the lower flange of the clutch cover (r.h.s.)
Picture of part attached.

Leave bike to cool on the centre stand allowing all oil to drain to sump and inspect window for oil level. It should just cover the window when bike is level. If the window is blackened from oil stains and no oil movement is detected, drain oil, remove clutch cover and clean window from inside with solvent and replace, replace oil with 2200cc oil, Cheers.510a044.jpg

Ad
czaa

Arnie Burke

  • 7339 Answers
  • Posted on Oct 11, 2010

SOURCE: I am needing a wiring

buy a battery eliminator from a harley shop or Exxel and it will start with the kicker

astrawoid

Eric Cross

  • 294 Answers
  • Posted on Nov 23, 2010

SOURCE: hello, hope you can shine

I see XS 400 , 650, and 850 for 1980. I see no XS 500's
I do find XT 500 and SR 500's
http://www.bikebandit.com/houseofmotorcycles/1980-yamaha-motorcycle-xs650g/o/m8271#sch214546

Check this out. is this your bike ?
look at line item # 20
1160212.

Anonymous

  • 73 Answers
  • Posted on Dec 30, 2010

SOURCE: I have a 1980 Yamaha

Get yourself a a oil pan trey to drip the old oil in. If you lay at the bottom of the bike you would see a big nut at the bottom should be a 17 or 15 inch, before unsrewing the nut (anti-clockwise) lay some newss paper under the bike and keep your oil trey near, position the oil trey below the nut just before you turn it completely loose best to undo it at the end by hand,
wait until all the oil has dripped out would advice replaceing the o ring inside the bolt you just removed.
once all the oil out you can put the srew back in
oil filter is just behind the manifold should be a 14 inch nut just loosen and remove the whole unit wil come out pull off the oil filter from the unit and replace with new one also replace any worn o rings and put back in then you may fill up with new oil .
Strongly advise buying you some good oil it's better to spend the extra money on oil that would prolong your engine and keep it running smooth

good luck

Anonymous

  • 1 Answer
  • Posted on May 22, 2012

SOURCE: what type of oil filter will fit a 2007 yamaha vstar 1300 other than yamaha filter

I use fram PH6017A. Get them at wall mart 6 or 7 dollars. about ten.or twelve dollars cheaper than one from yamaha also longer than stock so insted of 3.6 qt of oil I use full 4 qt. Hope this helped. Ride safe and have fun

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

YAMAHA XS400SG (1980) In restoring this bike, I did not notice that the oil filter is flat on one side and indented on the other. Which side of the new filter faces the engine block - the flat side or the...

If you look at the schematic for the oil pump for your bike you will see it in the lower left hand side. (link to bike bandit below) It appears to me that the indention is facing OUT away from the motor. Look at yours and compare it to the picture to make sure. I hope this helps!

Bruno

http://www.bikebandit.com/houseofmotorcycles/1980-yamaha-motorcycle-xs400sg/o/m8261
0helpful
1answer
Not finding what you are looking for?

86 views

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

vince

Level 3 Expert

2530 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

littlewheel

Level 2 Expert

122 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...