No diagram but could get one from Harley parts department or maybe this will help:
For removal block the motorcycle underneath the frame so both wheels are raised off the ground and then remove the cotter pin and washer from the pin and unhook the spring from the jiffy stand and anchor plate and pull the pin from between the frame tubes and then the jiffy stand and the pivot block will drop out together as one piece.
To reinstall the jiffy stand put the pivot block and jiffy the stand assembly between the frame tubes, install the pin through frame tubes and pivot block from the back towards the front and secure it with a new washer and cotter pin and then attach the spring to the anchor plate (the hook on spring will face up) and the jiffy stand. Ensure that the jiffy stand works properly before using it or relying on it to hold up the bike.
SOURCE: Wiring diagram for the Harley Davidson 2007 FXDB
If you are gonna work on your own Harley, shell out the $60.00 for an H-D manual. They have a basic wiring diagram inside.
SOURCE: Needing a wiring diagram for a 1981 HArley
I have one for an '84 model. About the only difference is the 84 model had an alternator instead of a generator. Other than that, it's about the same. contact me at [email protected]. I'll try to scan a copy from my service manual and shoot it to you.
SOURCE: engine diagram for 88 cubic inch harley davidson
I was able to pull up the complete maintainence book with wiring diagram, parts assembly, torque specs and part numbers by just going to www.1972 flh 80 harley davidson oem.com
SOURCE: 1974 Harley Davidson SPORTSTER TURN SIGNAL WIRING
I can help you with the wiring diagram but it will be the complete diagram. I have never seen just a turn signal only type wiring diagram. But, there's nothing to a '74 model Ironhead turn signal system.
All the wires for the system were gray but had these little "colored rubber bands" on the ends of the wires near the signal lights. The violet bands were for the left side and the brown bands were for the right side turn signals
Now, I cannot send the wiring diagram through this forum as it will not allow for an attachment. If you will contact me directly, I'll send you a wiring diagram as a jpeg attachment via e-mail. My address is [email protected].
Good luck
Steve
SOURCE: How do you replace the kickstand spring on a 2000 Harley FLHTCUI?
Have a friend hold bike up for you with the kickstand in,attach spring to kicks stand, and with a pair of needlenose pliers stretch the spring to attach to the loop on the frame
853 views
Usually answered in minutes!
×